Samsung Dishwasher Parts

While waiting for a replacement PCB, I cleaned the filter and soaked up the remaining water in the tub (dishwasher died mid-cycle) which entailed removing the dishwasher mesh filter and cover assembly of the pump assembly. The filter seal in the cover assembly and seal in the case scroll popped out. These two gaskets (seals) somehow had stretched and were very difficult to keep in their tracks while reassembling the pump assembly after cleaning. Replacement gaskets fit much better than the... Read more

I replaced both items. I lifted the racks out for clearance. with a small screwdriver, I flexed the flat springs holding the whole tube assembly. It came right out. Using the screwdriver, I popped the nozzle off, put the new one. I flexed the flat springs a little back into line to be able to hold the whole tube assembly, put the assembly back in, and pushed the spray arm onto the nozzle. Put racks in. done. Took less time than it did to write this fix it paragraph. Read more

Parts arrived faster than promised. I unscrewed both holder screws. The new arm snapped right in the new holder. Then screwed the new arm holder assembly back in to the dishwasher. The repair took only a couple minutes and dishwasher is working again. I am very satisfied with purchase and shipping speed. Read more

Replaced left hand rack adjuster. Read more

Research indicated that it may be a moisture sensor failure or a leak. It ended up being a leak from the oil seal on the motor shaft. A small piece of plastic made it's way into the system. The hot water softened it enough that it wrapped around the motor shaft, re-hardened, then tore into the shaft seal. I fixed it by replacing the shaft seal, moisture sensor (corrodes when it gets wet), and replaced the sump seal since I had it disassembled. Read more

• Will not dispense detergent

Removing the door panel was easy -- remove 6 Torx screws, and the panel falls off. Next you need to remove an electrical plug and 2 individual wires from the old dispenser. The plug came right off, but the wires were not easy to access, and they fought me more than I expected. With some pliers and wiggling, they eventually let go and came free. The dispenser is held in place with 6 Phillips screws through 2 removable metal brackets, and those came out easily. The toughest part of the job... Read more

2 year old dishwasher- "LE" leak sensor - found tinny leak in the shorh drain hose in - upon removing it this hose was found to be BRITTLE - VERY BRITTLE - main drain hose is fine - samsung says that this isnt a problem but have read quite a few complaints - easy fix unce unit is turned upsidedown. Read more

Found water in the bottom pan causing the the error code. Took off the side panel and turn the unit on and saw the hose leaking water. The hose material is cheap material so no surprise it leaks. Read more

• Touchpad does not respond
• Won't start

Here's what the problem was: Started the 'Normal' cycle... I closed the door... it calls for water, water fills, ECS sensor doesn't kick it to the next segment of the cycle (wash), so the water over-fills and reaches the over-fill sensor. So many other are replacing the plastic 'case-brake,' main board, and the ECS sensor. I, however, was able to get by with just the ECS sensor replacement, which is known to be a faulty design by Samsung, supposedly. The idea is replace the (1) most common... Read more

• Not drying dishes properly
• lights flashing or blinking

Replaced the heating element in the dishwasher. Read more

I removed the dishwasher, put it on its side, used a needle nose plier to remove the snapped piece of leg and screwed the new one in. Read more

Pulled dishwasher out about half way to expose the spring and rope attachment points. Installed new ropes on both sides and set the spring at the adjustment notch for optimum tension and counterweight. Read more