Dishwasher Timer Control Knob Parts
Genuine Ge part
By: Ge
Part Number: WD21X22276
Dishwasher won't start or lights are completely unlit? Main control board failure stops all functions. Moderate DIY repair restores power and cycles.
Do-It-Yourself Stories from Customers like You
No power Dave N. • Naples , FL • November 25, 2016
Called to check with model number and talked to someone who definitely said it was the main board that had gone bad. Revived it in a day and replaced it and my wife and life are happy again. This is where I go to for appliance repair.
Read more
More
$174.44
- Compare At:
-
$205.84
- You Save:
-
$31.40
Genuine Whirlpool part
By: Whirlpool
Part Number: WP8270168
Fix unresponsive buttons, cycles that won't start, or blinking lights. This user interface board restores control panel function in about 30 minutes.
Do-It-Yourself Stories from Customers like You
The start button would not work Ruth M. • Brooklyn , NY • May 10, 2016
1. Turn off the electricity to the dishwasher
2. Unscrew all of the screws on the inside of the dishwasher door.
3. Take off the door and put it aside
4. Loosen the panel that contains the control board, control panel and the door lock mechanism
5. Using a screw driver, push in the small moveable tab in the center of the plastic clip that is holding the control board to the plastic panel.
6. Unhook the ribbon that is attached to the bad control board.
7. Attach the ribbon to the new control...
Read more
More
$212.05
- Compare At:
-
$233.26
- You Save:
-
$21.21
Genuine Whirlpool part
By: Whirlpool
Part Number: W10854216
Fix dishwashers that won't start, stop mid-cycle, or display error codes with this electronic control board. Moderately challenging DIY repair.
More
$151.51
- Compare At:
-
$181.81
- You Save:
-
$30.30
Genuine Whirlpool part
By: Whirlpool
Part Number: W11368631
Fix a dishwasher that won't start or has no power with a new control board. This part coordinates all cycle functions and monitors safety features.
Do-It-Yourself Stories from Customers like You
Shuts down mid cycle Robert L. • Jeffersonville , IN • May 17, 2026
Display would flicker "Delay" light and then shut down. Replaced control board and door switch.
Read more
More
$133.37
- Compare At:
-
$157.38
- You Save:
-
$24.01
Genuine Whirlpool part
By: Whirlpool
Part Number: W11174552
This is the electronic phase control board that regulates the motor speed in a stand mixer. It adjusts power delivery to the motor based on the speed setting selected by the user. Replace this board if the mixer runs at only one speed, does not respond to speed adjustments, intermittently stops during operation, or fails to turn on entirely.
Do-It-Yourself Stories from Customers like You
Would not turn on Pat T. • Coeur D'alene , ID • December 13, 2015
I replaced the Board-Phas and speed control plate since power was not making it to the motor. When I received the speed control plate it had nuts on the upper screws with springs, since my old one didn't have nuts I assumed that the nuts were to keep the springs on until installed. After putting it back together, I noticed that though it worked, the first two settings did nothing. Now, guys, I was desperate, OK. I downloaded the service manual and read it from front to back, and when I got to...
Read more
More
$21.95
- Compare At:
-
$26.34
- You Save:
-
$4.39
Genuine Lg part
By: Lg
Part Number: EAM60991316
This is an electronic noise filter assembly that mounts on the dishwasher's power supply line. It suppresses electromagnetic interference generated by the dishwasher's motor and electronic controls, preventing it from affecting other appliances or electronics on the same circuit. Replace this part if the dishwasher trips breakers, fails to power on, or if you notice electrical interference with nearby devices when the dishwasher is running.
Do-It-Yourself Stories from Customers like You
No power. Semso M. • Tucker , GA • January 18, 2021
Replaced noise filter.
Read more
More
$84.95
- Compare At:
-
$101.09
- You Save:
-
$16.14
Genuine Bosch part
By: Bosch
Part Number: 00609266
Replace cracked, broken, or missing push buttons on your dishwasher control panel. This button set restores clean appearance and reliable operation.
Do-It-Yourself Stories from Customers like You
Top panel facia broke after several years. Dave H. • Watkinsville , GA • February 22, 2021
I ordered a new Panel/Facia and bought replacement buttons just to be safe. All were pretty easy, but two things to BE CAREFUL about that are important. First, watch the videos about how to remove and replace the facia panel because if you do it improperly you will easily break the plastic tabs and be screwed. Secondly, The five-button MUST BE INSTALLED IN THE RIGHT ORDER. They are different from each other and the DW will not work if you don't notice that, they have letters that are...
Read more
More
$23.95
- Compare At:
-
$28.50
- You Save:
-
$4.55
Genuine Ge part
By: Ge
Part Number: WD12X10353
Dishes not getting clean in the upper rack? A worn middle spray arm hub prevents proper rotation and water distribution. DIY fix in 15 minutes.
Do-It-Yourself Stories from Customers like You
Dishes were not getting clean; i noticed that the middle spray arm was not working; but also other spray arms appeared to have residue in the irrigation holes Margaret O. • University Heights , OH • November 08, 2014
I did an internet search - found your site explaining how to fix. I purchased the upper, middle, and lower spray arms - It took about 15 minutes total. Very very easy. No more dirty dishes!
Read more
More
$3.95
- Compare At:
-
$33.56
- You Save:
-
$29.61
Genuine Ge part
By: Ge
Part Number: WD35X10346
Fixes spotty dishes and rinse aid leaks. This reservoir holds and releases rinse agent during the final cycle. Quick DIY repair with video guide.
Do-It-Yourself Stories from Customers like You
Burned out motor and broken (stripped thread) rinse aid dispenser Norman G. • Winters , CA • October 20, 2015
Repair parts arrived super fast.
Installed the new parts according to the supplied instructions. All went well.
It took over 2 hours because the unit had to be removed after the water and power were disconnected and then the initial problem diagnosed (motor brushes worn beyond service limits). The removal of the spray bar tower assembly was a challenge until it was discovered that the tower unscrews in a CW direction from the bar that then allowed access to the attachment screw that holds that...
Read more
More
$41.63
- Compare At:
-
$49.96
- You Save:
-
$8.33
Genuine Bosch part
By: Bosch
Part Number: 00425565
Replace your dishwasher's on/off button when cracked, broken, or stuck. Mounts to the control panel fascia for starting and stopping wash cycles.
Do-It-Yourself Stories from Customers like You
Broken fascia on Bosch dishwasher. Jerry's W. • Washougal , WA • November 19, 2017
The old fascia had broken and been torn off. I should have saved the buttons from it, but I didn't know that I'd be repairing it - I figured I would have to replace the unit. Well, money is tight, so I got the model number from the unit and looked up parts online. I couldn't find the exact model number on this site, but the picture of the fascia looked just like the picture in my manual, so I bought it, a handle strip, and a new set of buttons.
I pulled the stainless panel off the front, then...
Read more
More
$19.77
- Compare At:
-
$23.53
- You Save:
-
$3.76
Genuine Ge part
By: Ge
Part Number: WD09X10025
Color: white. It measures about 2 inches in diameter by 2-1/2 inches deep.
Do-It-Yourself Stories from Customers like You
Broken knob. Judith B. • Saco , ME • April 02, 2019
The new knob I ordered fixed the problem.
Read more
More
$9.95
- Compare At:
-
$11.74
- You Save:
-
$1.79
Genuine Ge part
By: Ge
Part Number: WD21X10370
Dishwasher won't start, stops mid-cycle, or won't advance? Replace the main control board to restore proper cycle operation. Moderate DIY repair.
Do-It-Yourself Stories from Customers like You
Ge dishwasher filling then stopping and not going to next cycle Steven G. • Central Valley , NY • March 03, 2015
Turn off power to machine, Take off door panel - 12 screws. hold up door panel a bit and make sure to remove the ribbon from the touch pad to the control module (use some pliers to rock it out of the board). Since I was changing the Module, I just removed the 1 screw that held it in place and it gave me some more room to get my hands in there and remove all the wiring freeing up the board to remove the touch pad ribbon last (I didn't want to tear it because I was not replacing it and after 9...
Read more
More
$168.95
- Compare At:
-
$201.05
- You Save:
-
$32.10
Genuine Whirlpool part
By: Whirlpool
Part Number: W11413274
The Electronic Control Board is an OEM part for Whirlpool dishwashers. As the central processing unit, this board regulates all wash and rinse cycles according to preprogrammed instructions. It communicates timing and commands to other crucial components.
Symptoms of a faulty control board include:
- Failure to power on or unresponsive touch controls
- Inability to select or advance through wash cycles
- Noise or vibration issues from improper component operation
- Error codes appearing repeatedly on the digital display
Causes can involve water intrusion corroding circuits or individual component failure due to prolonged operation. Over time, environmental factors may inhibit board performance.
This OEM Whirlpool part can also be used on Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore/Sears brand appliances.
Do-It-Yourself Stories from Customers like You
E2 f2 Joe D. • Deerfield , IL • October 28, 2016
It's very easy fix. If your unit flashing e2 f2. It's your relay board take screw if on door couple latched s on the gray relay box pull wires harness of slow. Re install the same way it came of Just remember to cut the power off first . Leave your door open when re powering unit.
Read more
More
$81.95
- Compare At:
-
$97.52
- You Save:
-
$15.57
Genuine Bosch part
By: Bosch
Part Number: 00676960
Fix a dishwasher that won't complete cycles or runs indefinitely with this control board. Controls all wash cycles and functions. 30-minute repair.
This part fixes the following symptoms
-
Touchpad does not respond
See more...
Do-It-Yourself Stories from Customers like You
Stuck in 01 and wouldn't pump out & finish and shut off Harvey D. • Madison , CT • September 02, 2017
I ORDERED A NEW CONTROLLER BOARD. THE DIRECTIONS SHOWED HOW TO UNCLIP THE OLD BOARD BUT THE FASTENERS WERE ON THE LEFT SIDE NOT THE BOTTOM AS INDICATED ON THE REPAIR INSTRUCTIONS. AFTER REASSEMBLY THE DISHWASHER FUNCTIONED AS NEW. THNKS FOR THE INSIGHT.
Read more
More
$229.95
- Compare At:
-
$275.94
- You Save:
-
$45.99
Genuine Frigidaire part
By: Frigidaire
Part Number: 807022404
Fix a dishwasher that won't start, cycles not responding, or lights going out when door closes. This electronic control board restores cycle operation.
Do-It-Yourself Stories from Customers like You
Dishwasher acted like it was shorting out when I selected a cycle and shut door nothing would happen when door was open lights all worked fine shut again and nothing would happen and no lights Russell B. • Bossier City , LA • August 06, 2018
Bought the circuit board you recommended and it fixed it perfectly
Read more
More
$95.95
- Compare At:
-
$118.50
- You Save:
-
$22.55
Genuine Ge part
By: Ge
Part Number: WD09X10024
Replaces a cracked, stripped, or broken cycle control knob on your dishwasher. Mounts to the timer shaft to select and advance wash cycles.
Do-It-Yourself Stories from Customers like You
Needed a knob timer James M. • Lewiston , NY • October 30, 2015
I bought a new one from ApplianceParts PROS.com.
Read more
More
$7.57
- Compare At:
-
$9.08
- You Save:
-
$1.51