Dryer Object Stack Blower Wheel Parts

I encountered a high pitched squeal and loud rumbling. I figured the sounds were likely the rollers despite not matching other sounds on the repair videos for other dryers. The repair video for dryer rollers on AppliancePartsPros.com is of little use until Minute 2:56 because this Electrolux 517 model uses mostly Phillips head screw to fasten the front and top panels in place. You may find one latch at the top front center that holds the top and front panels in place. After unplugging the... Read more

• Will not tumble

Replaced the tension pulley assembly, drum rollers, drum roller axles, belt, and drum glides while I had the dryer disassembled. It turned out that the cause of the squeak was the tension pulley assembly, however it was easy and economical enough to replace anything that could have been the cause of the squeaking while I had the dryer apart. The parts were ordered on Thursday afternoon and delivered on Friday. I had the dryer repaired and running like new in no time. For about $100, it was... Read more

It was a relatively easy fix - if you know how to take the dryer apart. If you don't, there are plenty of YouTube videos explaining how. Make sure you find your model. Since the wheel had separated from the nut, it wasn't quite as easy and holding the shaft and loosening the wheel. I had to remove (destroy) the wheel first. Then I was left with the nut on the shaft. The nut was seated on the shaft a lot tighter than I expected and took some force to get off. Once it was off, putting the new... Read more

• Too hot
• Doesn't shut off
• Takes too long to dry

I replaced the dryer motor. I followed the repair video on the Appliance Parts Pro site, with a few modifications to the procedure. I loosened the control panel and flipped it forward to improve access to the wiring connectors. I also loosened the front panel and tipped it forward before disconnecting the door switch as there wasn't enough space to disconnect the switch otherwise. Removal of the blower assembly required the use of penetrating lubricant as the assembly was stuck on the motor... Read more

• Noisy

Order set of drum rollers. My dryer required four. As long as I was opening up the dryer, dryer, 10 years old, I wanted to replace all of them. Also ordered new belt for Sam reason. Found full manual online. Disassembled dryer, about 20 screws. Replaced rollers, although only one was squeaky. Put it all back together. Took about 3 hours. Read more

Took dryer apart. Replaced roller, 45 minutes, done. Read more

I purchased a new blower wheel and replaced it. It saved me about a $200 repair bill. Read more

Replaced the top bearing assembly, drive belt, and blower wheel. The most time consuming and difficult part was putting the new drive belt back on the pulley and tensioner. Be sure to know how it is routed through them. It is a very tight fit getting your arm in there and connecting it blindly. Read more

I replaced the drum bearing in the back and also the nylon sliders in the front. It rook some time but was not difficult. I took some extra time to thoroughly clean all the lint from the inside. Read more

I disassembled my dryer and found that the fan(blower wheel) was "free-spinning" on the motor shaft. A common problem with this model Maytag dryer. I also discovered that the right drum roller (drum support roller) was in the process of failing. Note: the fan drive was frozen on the motor shaft, this was the threaded type of motor and fan assembly. I was able to remove the fan drive by using vice-grip pliers, hammer and a combination wrench to hold motor from turning. Also Note: the fan... Read more

Blower wheel and clamp replacement. Initially, we replaced both the belt and drum roller wheels but that did not stop the noise. By reviewing videos on YouTube and AppliancePartsPros, we suspected that the blower wheel could be problematic, even though with front panel of dryer off, we did not see any visual clues to support that theory. Purchased the replacement clamp as well, just for good measure (and it was inexpensive). Note: we did call AppliancePartsPros with our model AND serial numbers... Read more

Replaced Blower Wheel. Stress cracks at center of blower wheel. Read more

After replacing the belt less than a year ago, when it broke again we started to think something may be going on with the idler pulley. Ordered a new belt and pulley wheel, only to have the belt break again the very next day. After a call to customer service explaining the situation, they replaced the belt and pulley wheel which were both under warranty, and suggested replacing the arm itself. We also had to replace the interlock switch. Parts arrived quickly. The repair itself took about an... Read more