Msd255oveso1 Parts

The ice dispenser chute door had not been sealing for years. The ice cubes on the lower portion of the ice bin would melt enough eventually to then freeze up into a big, amalgamated blob of ice due to ambient air coming up the chute. This melt-then-freeze would happen, to the extent the chute froze to its own closure. Despite service technician visits over a period of six years nothing they did resolved the issue. I opened the freezer door to reach into the bin from the top to extract usable... Read more

It was not looking good. I could not order the part I needed as it was part of the door - eve though it had screws att Hong it to the freezer door. At one web site it was a replacement of the whole freezer door!/? Luckily I ventured further and found this repair kit and video instructions. My order arrived in 3 days, and the install (thanks to the video) was easy. A whole lot better than buying a new freezer door - not! BTW - Whitlpool should not have made the tabs out of plastic, the metal... Read more

Had to replace the auger. The auger on my ice maker was made of plastic and had broken pieces off it. The new one is made of metal and seems to work much better. Was a fairly simple repair. However pay close attention when disassembling, I recommend using your cell phone and snap a pic of the different stages as I became a little confused when putting it back together. Ordered the part and it was here the next day. I'm very happy to have my ice coming down the chute again. By the way, I'm a 70... Read more

• Noisy
• Freezer section too warm
• Fridge too warm

Removed back panel in freezer compartment. Held on by four hex head screws. Disconnected wire assembly from panel and then replaced evaporator fan motor on kitchen table. Evaporator fan motor is attached to back side of freezer panel by four hex head screws. Easy repair to do.It took me about 30 minutes to do the repair. Read more

I put all pieces that I ordered on the dryer and plugged it in. Read more

Undid a handful of screws, put the new panel in place and screwed them back in. Read more

Was stuck finding the correct parts, as the numbers on the Whirlpool website did not match exactly. But your rep was very patient and helpful with measurements and descriptions to help me find the exact parts I needed. Everything was perfect! Thanks ever so much. Read more

I found a video/tutorial on how to take it apart to see what was pieces were broken, then ordered the replacement parts and watched the video to put it back together again. Read more

• Freezer not defrosting

Order part at appliancepartspros.com *( Heater and Thermal Assy. ) and with that I watch a video on how to repair my fridge. It took me about 15 minutes to replace the parts. I think it took me longer than that to watch the video itself because I want to make sure that I will do it right. Replacing a part is very easy, now after two weeks my refrigerator is running good so far !!!! Read more

Maytag Dishwasher (about 5 years old). Some of the buttons had stopped functioning. Then the Start button began choosing whether or not to work. Eventually it would not start at all. Upon removing the control panel, the first thing I noticed was that the brackets that hold the two lower screws were broken. (So this was the reason that the door was so hard to open from the time it was new.) I trouble shot the thermal fuse, the door-latch switches, and inspected the control board trying to find... Read more

I replaced the Ice Dispenser Lever. Since the replacement part is only available in white and my fridge is bone, I replaced also the Water Dispenser Lever, so it looks much better. I followed the instructions in the video, which were very useful and very well done. My problem was that the refrigerator is a KitchenAid built-in, while the instructions were for a Whirlpool, so the removal of the faceplate was quite different from what was shown in the video and more difficult. Also there were some... Read more

My LG electric dryer stopped drying the other day and I searched on line for suggestions on what may have caused it to stop working. I came across AppliancePartsPros.com and quickly found some of the most common issues with my LG dryer. The problems were listed in the order of most common occurrence, and had extremely helpful and detailed instructions on how to not only diagnose the problem, they also showed exactly how to access and repair the issue. Unfortunately, it was late on a Thursday... Read more

Removed the handle with two screws on the inside front and pulled out the custom wood panel. Pulled the compactor out from under cabinet. Tipped it over on back of unit, supporting it with a little foot stool. Unscrewed two lower screws at bottom of unit holding black trim panel (that held wood panel in place) and lower black rubber flap. Removed two screws on lower outside side of unit that held the foot pedal. Slid off black U shaped metal frame from top of compactor towards bottom. Slid on... Read more

Left side wheels damaged from tenant running over floor register. Replaced all 4-rollers in rear and front of the refrigerator. Appliance Parts repair video was important to the success of the replacement. Read more

I don’t think I needed the capacitor and relay, but while I was at it I figured I would. Originally we found we had an issue when water cane out of the ice maker. The freezer was hovering around freezing and the refrigerator was about 33 deg. I unplugged the refrigerator and it came back on and ran about a day. The next night, same thing. This time cycling power did not seem to help. Removing the rear cover where the control board was and moving it around allowed it to turn on next time I... Read more