Msdd2454gw Parts

Replaced the upper and lower racks. AppliancePartsPro shipped the racks fast and they are a perfect fit. I think they're even a better, stronger design then the factory originals. Read more

• Ice maker dispenses too much ice

Ice Door Kit, Control Bracket, and Ice Dispenser Guide were purchased. I followed two videos on replacing the parts. The Control Bracket WP2180226 / AP6005965, was straight forward and I discovered a snapped pin on the old bracket causing an electric switch to be out of place... that repair was easy. When it came to the hinges of the ice chute, I discovered the snap-in, on right side, of the hinge was cracked... this is why the pin escaped. This cracked part is molded into the entire... Read more

• Fridge runs too long
• Noisy
• Freezer section too warm
• Fridge too warm

After reviewing the 'how to' video on AppliancePartsPros.com, I unplugged the refrigerator and removed the back cover to access the motor. I then unplugged the wiring and removed the bad motor. I cut the clip plug and wired it to the new motor, installed the fan blade from the old motor and re-installed the new motor. After connecting the clip plug and re-installing the back cover, I plugged the refrigerator in and checked the interior about 5 minutes after the repair. Everything has been... Read more

Our Kenmore (Whirlpool) refrigerator's ice maker had stopped making ice. I searched YouTube and found a repair videos for this exact problem, finding one with a similar refrigerator and the identical ice maker. I learned that the Water Inlet Valve had likely gone bad and would need to be replaced. In the video the tech pointed out the small rubber tube inside the freezer that comes down from the ceiling of the refrigerator into the ice maker. This tube feeds it the water to make ice with and... Read more

Replaced the starter and capacitor, 30minutes, $60.... Bam!!! Fixed Read more

• Not dispensing water

I watched the Appliance Parts Pros repair video and decided to remove the front panel to diagnose the problem. While the repair video is excellent, I could not remove the ice/water dispenser front panel with a putty knife. On my model, 106.56234400, there is no clip that can be released by sliding a putty knife up under the front panel. It took a little effort but I was able to pop the left lower corner clip just by pulling it out with my fingers. Once the cover was off I could see that the... Read more

Appliance parts pro DIY video clips extremely useful. I recently purchased this home and like DIY projects if the repair isn't too difficult. In the end I save on costly labor fees and it's more rewarding to fix it myself. I have an ice and washer dispenser on the outside of my refrigerator and wanted to use it. When I first looked at the home there was a sign posted next to the refrigerator "Do not turn on water valve, leak under the refrigerator". It was an "as is" property. My agent... Read more

• Won't start

The full story: Dishwasher stopped running mid-cycle. When I first began troubleshooting I tried manually advancing the timer knob, and the machine would run. That led me to believe that the actual timer assembly was bad, so I replaced it. The dishwasher ran fine for a day, and then the same problem came back. This time, however, I also had to push in on the door to get it to run. I looked around online, and someone suggested that the door latch wasn't closing tightly enough. I adjusted the... Read more

• Noisy
• Fridge too warm

The fridge is 20+ years old in a home we recently moved into. It sounded like a motor getting stuck on something or grinding weird... was hoping it wasn't something more serious. Found this site, clicked 'noisy' and got the replacement evaporator fan motor blade as well as the motor evaporator. Turned out I didn't really need to replace the fan blade, but since I had it and ours was old, figured I might as well put in the new parts. Followed the videos here, which were really helpful. The... Read more

First I thought it was the defrost timer (talking to a friend). Replaced as $30+ dollar part and cheaper than a service call. Unfortunately, that did not help. Did some google searches and came across ApplicancePartsPros.com. They had a ton of useful information from chat availability to videos. Through the chat, we determined most likely it was the thermostat. I ordered it with expedited shipping and it shipped the same day and arrived earlier than expected. However, the part looked... Read more

• Ice maker not making ice
• Ice maker won't dispense ice

SO I FIGURED THAT ALL THE MECHANICAL PARTS OF IT WERE FINE SO THE LOGICAL THING TO DO WAS TO REPLACE ELECTRICAL COMPONENTS WHICH CONSISTED OF THE THERMOSTAT {THE BRAIN} AND THE CONTROL MODULE WHICH I PURCHASED AT A VERY REASONABLE PRICE . I REASSEMBLED THE UNIT AND IT HAS BEEN WORKING LIKE NEW EVER SINCE. THANK YOU! Read more

I took apart the old bucket with a screwdriver and put the new one with no problems. Read more

About a year ago my dishwasher during a cycle was emitting a horrible plastic burning smell. We stopped it mid-cycle, cleaned it out and tried to run a few more cycles after that and realized it wouldn't drain so it sat in my kitchen broken for a year. I finally got so fed up with washing dishes by hand that I took the whole dishwasher apart. Confirmed there were no blockages in any of the hoses etc. when it still didn't work I googled the problem, found this website and found that it must be... Read more

• Door won't open or close

I replaced the door cams and the thimble bearing. Read more

• Too warm
• Clicking sound
• Won't start
• Freezer section too warm

Thank you to everyone who entered comments, especially about the "Clicking" sounds when it was trying to turn on the compressor. I did not notice them at first, but then heard them and was confident that one of these parts (or both) had a problem. In my case, I have custom cabinets around the sides of the refrigerator and hardwood floors in the kitchen so I put down some cardboard when the rollers would need to go at an angle due to a center island in the way. (I would rather do this myself... Read more

I tried duct tape but then decided to buy the parts from Appliance Pro's and fix it correctly. It looks brand new now. Thank You :) Read more