Rf268acsr Parts

Ordered the two motors plus ordered the fan blades since I was afraid one might break during replacement. Changed out without breaking Freezer and both ice makers now working fine Read more

I took all the items out of the refrigerator. Removed the screws that hold the cover over the evaporator motor. Than for three hours used a hair drier to remove ice. The panel was frozen on if you pull on it it will break. Soaked up all the water removed the panel and took the fan blade off. That was difficult because it looks like a regular screw head however, you need to push in that which will cause it to release the blades and than push it onto the new motor. Than replace the panel put the... Read more

Using the website, I was able to locate the part and order it Read more

First, I modified old butter knife by bending a 90° angle about 3/4" from the tip. I slid the bent in up under the bottom of the switch cover and worked it to one side. I then rotated the knife downward using the bent end to pry the cover off. The switch is held by plastic arms on each side. The bottom right arm has a locating pin that fits into the switch. Unplugged the switch and re-installed. Read more

I have a large Samsung 4 door refrigerator. One of the rear wheels broke. To replace it, you need the wheel and the shaft. To lift the refrigerator for the repair, I had my wife stand in front of it with her foot on a board that was wedged against the front wheels. I then pushed the refrigerator up from behind and slid a 3/4" piece of plywood underneath the bottom with my foot. This gives you enough space to do the repair. After removing the back cover, it's best just to knock out the broken... Read more

Samsung does not make it easy to replace the casters. The shafts holding the casters are crimped at the ends and had to be cut off with little room for any tools. I had to jack up the fridge and I used a hacksaw blade with a handle to cut through the wheel shafts. I didn't want to use a reciprocating saw. I couldn't find a way to crimp the new shafts so I drilled small holes at the ends and used cotter pins to retain the shafts in place.The rear caster had no room to slide the new one in... Read more

• Frost buildup
• Doesn't shut off

Ordered parts, defrosted refrigerator, and replaced with new items. This problem has been going on quite some time, while Samsung refused to acknowledge the defective unit, claiming it was owner fault. The defrosting had to be completed every 3-4 months and managed in time to require defrosting every few days. Originally a repairman came and although he defrosted it the first time, he informed us, this is quite common and the unit is defective by design; which is why we continued to defrost on... Read more

Used the video with the parts and replaced the wheels. The only thing we did wrong was using the front wheel axle instead of the back wheel axle on the back wheels. I will just order two more front wheel axles which are longer than the back axle. Thank you for the video, it made this repair easier. Read more

Samsung does not make it easy to replace the casters. The shafts holding the casters are crimped at the ends and had to be cut off with little room for any tools. I had to jack up the fridge and I used a hacksaw blade with a handle to cut through the wheel shafts. I didn't want to use a reciprocating saw. I couldn't find a way to crimp the new shafts so I drilled small holes at the ends and used cotter pins to retain the shafts in place.The rear caster had no room to slide the new one in... Read more

Ordered tank and heater, installed, so far so good. Thanks for the speedy order Roman Read more

I looked at the blow up drawing to figure out what parts I might need. I then watched a you tube video to see how to take the handle off. I kind of figured out on my own how to remove the ruined cap handle. It took me a few minutes to figure it out and more time to remove both the handle and the broken part. Turns out I did not need the spring nor the shaft cap handle. Very proud of myself. Saved a huge amount of money. Only problem was that I could only put in one screw as the previous... Read more

At first, I contacted the number listed in the manual to order the part, the customer service person was no help after 30 minutes of trying to explain what part I needed I think she got it, but then told me it would take 5-10 business days to get it, and they could not ship any faster. So, I cancelled the order and while I was on hold for her I searched the internet and was able to find your website called you had a diagram of the part I needed and it was shipped out the same day and I got it... Read more

Unscrewed old flap. Then unplugged it. Plugged in new flap ( make sure it is right side up). Screw both hinges back, and voilà, fridge fixed! Read more

I replaced the control board and the microswitch. Read more

Ordered tank and heater, installed, so far so good. Thanks for the speedy order Roman Read more

Replaced sensors and heater element. We'll see if that fixes the problem. It usually happens every 3 months. Read more