Need Help?
Call
Some parts shown may not be for your model. To see parts for your model only, select it from "Matching Model Numbers" list on the left.
This washer drain pump moves water out of the washer during drain and spin. Replacing a worn or failed pump restores proper draining so cycles finish on time and the basket can reach full spin speed.
What it does
What’s included One drain pump assembly.
Install notes
This OEM drain pump is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore models.
Ordered the correct part/ Pump from this Awesome website and replaced the drain pump. Good to go!! Read more
Fix a washer that won't agitate or clean clothes properly. This agitator replacement restores wash action. Moderate DIY repair, requires removing bolt.
I had to cut the old agitator out with an oscillating saw in order to access the agitator drive. This is the second Maytag (MVWC 565) I have had to do this to. I first tried removing it by sliding straps under the agitator then then using a jack to pull it loose which did not work either time. One suggestion I have would be to remove debris from tub as you cut in order to prevent it from dropping from the inner tub into the outer tub. Read more
Transmits power from motor to tub for spinning and agitation. Replace if squealing, squeaking, or washer won't spin. Confirm fit with your model number.
Replaced the Gearcase assembly which is a sealed unit that is not serviceable. Also replaced the clutch and belt because they were covered in gearcase oil. Read more
Fix a washer that won't start or stays locked with a new lid lock assembly. This safety latch secures the lid during cycles. DIY-friendly repair.
Replace lid lock switch Read more
Fix a washer that won't agitate or spin with a new washplate. Stripped splines are the most common cause. Simple DIY repair under 1 hour with video.
Popped off cap on middle of plate inside machine with flathead screwdriver, used a ratchet wrench and socket on bolt, took off plate. Replacement OEM plate was about $88. Got to house in 3 days. Less than an hour total time. Machine was 1 1/2 years old. It had stopped spinning, making noise. Read more
The Capacitor is an OEM part for Whirlpool washing machines. This part helps regulate power supply and voltage levels. It smooths out voltage fluctuations to ensure consistent operation of the motor and internal components. Causes of a bad capacitor can include faulty wiring connections, or simply wear and tear over time. Capacitors have a limited lifespan based on usage and wear. Symptoms of a bad capacitor include:
This genuine Whirlpool OEM replacement part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore models.
Bought one from you and replaced it. I friend did it for the family. Read more
Fix a washer that won't fill, fills slowly, or won't stop filling. This water inlet valve controls water flow during wash cycles. 30-minute repair.
Ordered the valve body from Appliance Parts Pro. It was very easy to find the part on their website. Ordering was simple. The part actually got here the next day. I received an email about 2 hours after I received the part that contained the tracking number. That is what is known as quick and reliable service. Part was a little hard to replace since I have big hands. There are 2 metal screws that hold the valve body to the washer that are in a small confined area. Unless you want to dismantle... Read more
Fix a washer stuck in sensing mode or won't spin with a new shift actuator. Controls cycle transitions between agitation and spinning modes.
Diagnosed the problem, and tracked down the part I needed at Appliancepartspros.com Read more
Fix a washer that won't fill, fills slowly, or drips when off with a new water inlet valve. Most DIYers complete this repair in 20-30 minutes.
Installed new Water Inlet Valve. Read more
Washer won't start because lid won't lock? This lid latch strike secures the washer lid during operation. Simple DIY fix in under 30 minutes.
Not wanting to spend hundreds of dollars on an appliance technician's service call, I searched online to troubleshoot the problems with my particular Maytag Washer Model Number MVWX500BW0. I stumbled across AppliancePartsPros.com and investigated there the most likely causes for my Maytag Washer's not agitating properly and not spinning at all. In order to acquire some additional information, I telephoned AppliancePartsPros.com and spoke with an extremely professional, knowledgeable and helpful... Read more
Filters debris from water entering your washer and seals the hose connection. Replace if water fills slowly or screens are clogged. Confirm fit by model.
As a Mechanic, I did the common sense approach: INITIAL OBSERVATIONS & CHECKS: - Unplug Machine & check inlet water hose connections for leaks and signs of hose failure; - Remove back panel & inspect for water presence at all hose connections, pump, bottom of basket (bottom center of basket where the main motor, shaft bearing, and tub seal is located), dispensers, bottom of wash basket, water injector area, look everywhere where there is a hose connection and where water flows... - Inspect... Read more
This is a D-shaped knob insert or spring clip that fits inside a control knob and connects it to the control shaft on the dryer's front panel. It ensures the knob grips the shaft properly so you can turn the timer or selector. Replace this insert if your control knob spins freely without engaging the shaft or if the knob feels loose and won't stay in position.
I purchased the lid latch assembly and the lid switch strike. Following the clear video instructions for each part, my handy teenage son was able to remove the lid latch assembly and replace it with the new part as well as the lid switch strike. The washer is back to working perfectly for under $100. Appliance Parts Pros carry the parts to repair and at a lower cost than other online retailers. I saved about $30 compared to the other online site and I saved a service call fee. I'm so glad I... Read more
Flexible tube that drains used water from your washer tub to the standpipe. Replace if cracked, leaking at connections, or torn along the length.
After not finding the needed parts to extend the hose at home depot, i turned to online help. I was able to find the right parts quickly on your site and was able to even watch a few videos on how to do the repair. I was beyond amazed that the parts arrived the next day, even though a Saturday and even with standard shipping. I was fortunate enough that my repair did not need any real explanation and the job was done in less than 10 minutes. Felt really good to be able to solve the problem,... Read more
Four suspension rods with bushings that secure the washer tub and absorb vibrations. Replace if rods are cracked, worn, or bushings are damaged.
Replaced suspension rods Read more
The Drive hub retainer is an OEM replacement part for Whirlpool washing machines. It connects the drive motor and agitator gear, transmitting rotational power from the motor to enable drum rotation during the wash cycle.
Causes of a bad retainer can include wear and tear over time, cracked or damaged retaining clips or plastic components, or failure of the retaining mechanism that secures the hub in place.
Symptoms of a bad retainer include:
This OEM Whirlpool part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore models.
Replaced tub seal. It was a big challenge for me since it was the first time I do something like that. It was just a worn-out little seal at the bottom but in order to get to it, I had to dissemble almost the entire machine. I felt pretty good afterward. Read more
Washer won't drain or shows DRN code? This drain pump removes water from the tub each cycle. DIY-friendly repair with video guide included.
Its under warranty so I called Sears repair. The Technician determined the pump was bad order. After a month of waiting for Sears to order the part and the back and forth on the phone, I looked for the part myself. You guys sent the part and in 2 Days my washer is working again. No word yet, from Sears part order.. Read more
By continuing to use our site, you agree to our Terms of Usage and Privacy Policy. You can learn more about how we use cookies by reviewing our Privacy Policy.
We use cookies to optimize website functionality, analyze the performance, and provide personalized experience to you. Use the controls below to manage your privacy preferences.
Cross-Site Advertising
When enabled, we may use cookies and similar technologies to deliver personalized advertisements based on your browsing activity across different websites. Opting out will disable third-party advertising cookies on this site.
Analytics Sharing
When enabled, we may share anonymized browsing and usage data with third-party analytics providers to help us understand how visitors use our site. Opting out will prevent this data from being shared with third parties.