Control Panel Lcd Parts

An aluminum drip pan was placed into the bottom of the oven thinking that it would make for easier clean up......Don't Do It! It melted to the bottom floor of the oven and could not be removed. It was infused with the coating on the floor pan, thus making it permanently damaged. After a quick search of the internet, a replacement part was found at AppliancePartsPros.com They had the part I needed at a very good price. It only took me about 5 minutes to change out the old part with the new one... Read more

Replaced the board and put it back together. Read more

There was no power coming out of the control board to the igniter so I replaced the board and walay it work and all is good in the kitchen Read more

• Freezer section too warm
• Fridge too warm

Replaced the heater, timer, and wiring harness Read more

My teenaged son took the old washer door off and apart. He replaced our glass from our washer onto the new doors and attached it to the hinge. These doors are compatible with Kenmore washer even though it says Frigidaire. Read more

I diagnosed the problem, identified faulty parts, and replaced those components. Read more

Ordered part from appliance parts pro,replaced and dryer is drying again Read more

• Fridge too cold

Easy fix in less than 10 minutes. I replaced the thermostat control. I first shorted the two wires that went to the control and let it run for 1 hour. The temperature was dropping and the freezer was freezing. Read more

Got on line, looked up the model #, looked at the parts diagram, found what I needed and placed the order. Couldn't have been simpler. You folks are GREAT!!!!!! THANKS Read more

• Little to no heat when broiling

We ordered the Pwb(pcb) Assembly,sub, Part Number 6871W1N012B & received the part the next day. I couldn't believe how fast. My husband was able to replace in 15 minutes. My oven worked again! Read more

I installed the new one and it went in easily...I like the new door better than the old one because the old door would always open and spill the butter when I shut the fridge door but the new door has like a catch that keeps it from opening when I close the refrigerator door. It works great. Read more

I replaced the defrost thermostat and the defrost timer. That corrected the problem. Be careful when ordering your parts. I put in my model# and they gave me a defrost timer that was incorrect. I had to return at my cost and order the correct one. Don't assume because you put in your model# that the part is correct. On each part there is a box to put in your model# to check to see if it fits your model. Don't assume that because you put your model# in before that it fits. If not sure, call them... Read more

The glue behind the keypad loosened and the keypad slowly began slipping down out of place over several months. Finally, because of the movement, it warped which resulted in one of the keys being stuck. That is what gave the F12 error code. The fix was easy. I removed the control panel and then peeled off the keypad. The keypad itself then has two layers (1), the flexible circuit panel, and (2) the outward facing display. I separated the display from the circuit panel and put the new one... Read more

I searched online and easily found the best price for the Front Plate Assembly to be AppliancePartsPros.com. Even though I didn't pay for two day shipping, the part was shipped the next day and received the following day (Saturday), outstanding service. Installing the piece was quite simple, requiring removing two screws, slipping the old part off of two retaining clips and disconnecting one wire connector. Reverse this to install new part. Read more

• Won't start

I purchased a new igniter for the bake assembly and found that it, unfortunately, did not resolve my problem. I measured the resistance of the different points on the gas valve and it was reading within spec so I then purchased this spark module and it did the trick. My gas range is a Kitchenaid kgsk901sss02. I had a LOT of trouble finding where the spark module is located, and eventually found a schematic that shows it's location behind the front control panel of the oven. Upon taking the... Read more