Power Strike Small Engine Spark Plug Parts
Genuine Ge part
By: Ge
Part Number: WE04X25195
Fix a dryer that won't heat properly or overheats with this thermostat. Senses exhaust temperature to regulate heat cycles and prevent damage.
More
$20.95
- Compare At:
-
$24.93
- You Save:
-
$3.98
Genuine Whirlpool part
By: Whirlpool
Part Number: WPW10375379
Washer won't start or shows F28 error? Door lock keeps washer secure during cycles. Moderate DIY repair, takes about 15 minutes with door boot removal.
Do-It-Yourself Stories from Customers like You
Door lock was broken Kerry K. • Clyde , TX • August 23, 2015
ORDERED IN DOOR LOCK FROM ApplianceParts .received part next day. ( Great delivery time!) went down and installed on my washer at the Laundry.Took about 15min to install. I had very little down time at my business.
Read more
More
$173.68
- Compare At:
-
$204.94
- You Save:
-
$31.26
Genuine Whirlpool part
By: Whirlpool
Part Number: WP37001136
This cycling thermostat regulates exhaust temperature by switching the heater on and off to maintain proper drying heat. Replacing a failed thermostat restores consistent temperatures, helps auto-dry timing, and protects against fabric-damaging overheating.
- Controls the heating circuit to maintain target drying temperatures
- Provides temperature feedback for accurate auto-dry operation
- Common symptoms: long dry times, very hot drum/cabinet or scorching odors, auto-dry not advancing correctly, or no heat if the thermostat fails open
- Typically mounted on the blower housing to sense exhaust air temperature
Includes: 1 cycling thermostat. Install notes:
- Disconnect power; for gas dryers, also shut off the gas supply
- Access the thermostat (commonly on the blower housing); remove the necessary panel(s)
- Transfer wires one at a time to the new thermostat and mount it flat against the housing
- Reassemble, verify clear venting/airflow, and run a test cycle
Do-It-Yourself Stories from Customers like You
Heat was too high Douglas S. • Mesa , AZ • May 17, 2015
I went ahead and ordered the element, and the 2 different thermostats not knowing exactly which one might be the problem. My My Maytag opens from the front and it was actually pretty easy to get into. Also gave me the opportunity to vacuum out the inside of the dryer. Pop the top off, remove the wires that connect the door switch (noting the colors and placement), take off the 2 inside nuts that hols the fron on, pull it forward and lift it off, 3 inside screws to take out to inside lint part...
Read more
More
$81.71
- Compare At:
-
$97.23
- You Save:
-
$15.52
Genuine Lg part
By: Lg
Part Number: 4026EL3007A
The Door Strike is an OEM part for LG dryers. This part engages with the door catch to keep the dryer door securely closed during operation. The door strike is essential for ensuring the door remains tightly shut, allowing the dryer to function efficiently and safely.
Causes of a bad door strike can include wear and tear from regular use, damage from slamming the door, or misalignment issues that prevent it from engaging properly with the door catch.
Symptoms of a bad door strike include:
- The dryer door not staying closed
- The dryer not starting due to the door not being securely latched
- Difficulty in latching the door
- Visible damage or wear on the strike
This OEM LG part is also compatible with Sears/Kenmore.
Do-It-Yourself Stories from Customers like You
Dryer door latch broke Bryan G. • Happy Valley , OR • February 11, 2019
Chatted with 1 of your professionals and within a minute she had the part and it was on it's way. The job was VERY easy to fix and the part is working great!
Read more
More
$47.41
- Compare At:
-
$56.42
- You Save:
-
$9.01
Genuine Speed Queen part
By: Speed Queen
Part Number: D510702
Dryer not heating or overheating? A failed limit thermostat stops heat when temps climb too high. Simple DIY fix restores safe, reliable drying.
More
$27.46
- Compare At:
-
$32.40
- You Save:
-
$4.94
Genuine Frigidaire part
By: Frigidaire
Part Number: 134936800
If your washer won't start or the lid won't unlock, the lid lock switch may have failed. This DIY repair typically takes 10-15 minutes with basic tools.
Do-It-Yourself Stories from Customers like You
The locking mechanism would not release the lid had to break it to open Dennis H. • Bridgeton , NC • January 10, 2015
1) Ordered part.
2) Removed front panel by loosening the two screws at the bottom front.
3) Removed old Safety Switch/Lid Lock by disconnecting wires (plug and 2 female disconnects)
4) Reconnected all wires and reinstalled switch.
5) Replaced front panel.
6) Tested Unit.
7) FYI - I found that the locking mechanism stays locked until cycle completely finishes on its own. DO NOT force the cycle to end. Lid will NOT unlock.
Read more
More
$87.95
- Compare At:
-
$103.78
- You Save:
-
$15.83
Genuine Frigidaire part
By: Frigidaire
Part Number: 5304485407
Microwave door won't open when you press the button? This door release lever connects the button to the latch mechanism. DIY fix in 30 minutes.
Do-It-Yourself Stories from Customers like You
Microwave door will not open Chris B. • Louisville , KY • July 04, 2017
Turn off breaker, remove all screws { 4 on mine } inside oven door holding oven and microwave to kitchen cabinet and slide oven assembly out of cabinet {on to a temporary shelf of {4} 5 gallon buckets/plywood/bricks/shims that I made on the floor atop a scrap of carpet} just enough to access the side and rear screws of microwave's protective metal housing, then remove a total of 16 screws { there were 2 screws just inside top of "opened" microwave door that were holding top flat silver metal...
Read more
More
$62.51
- Compare At:
-
$73.76
- You Save:
-
$11.25
Genuine Whirlpool part
By: Whirlpool
Part Number: WP307249
Fixes dryers that won't shut off, run too hot, or take too long to dry. This cycling thermostat regulates drum temperature. 15-minute DIY repair.
Do-It-Yourself Stories from Customers like You
Regular cycle did not work and air fluff didn't work Ronald R. • Jupiter , FL • March 15, 2018
Put both thermostats in as I did not know if the unit was cycling on high limit at times. Fixed both issues plus I used my lawn blower and blew all the lint out of dryer and short 3' hose. I also lubed rear drum bearings. Works like new. Ron R
Read more
More
$75.68
- Compare At:
-
$90.06
- You Save:
-
$14.38
Genuine Whirlpool part
By: Whirlpool
Part Number: WP3406653
This sensor harness connects the dryer's moisture sensor bars to the main wiring, helping the control or timer read moisture levels so Auto Dry cycles can advance and deliver consistent, reliable drying performance.
- Provides the electrical path between the moisture sensor bars and the control/timer
- Enables the dryer to sense wet fabrics and adjust or advance Auto Dry cycles
- A damaged or open harness can cause Auto Dry to not advance, run too long, or stop early
- Contribute to inconsistent dry times or a "Sensing" indicator that behaves abnormally
What's included: One sensor wire harness Install notes:
- Disconnect power before servicing
- Access the sensor bars at the front bulkhead; note wire routing and clip locations
- Transfer routing/clips from the old harness; connect to both sensor bars and the main harness plug, ensuring snug terminals and clear wire paths
- Restore power and run an Auto Dry test; inspect/clean the sensor bars and check harness continuity
Do-It-Yourself Stories from Customers like You
Dryer turning off on auto cycle with clothes still damp Mark F. • Topsham , ME • January 31, 2015
Replaced 3 low cost parts as advised by Appliance Parts Pros. Saved the labor costs by troubleshooting and replacing parts with their great videos. Works like new, and took 15 minutes to complete the repair.
Read more
More
$80.95
- Compare At:
-
$95.52
- You Save:
-
$14.57
Genuine Lg part
By: Lg
Part Number: EBD50964602
The Pressure Sensor is an OEM replacement part for LG dryers. This sensor monitors the airflow or pressure within the dryer, helping to regulate drying cycles and ensure efficient operation. By detecting blockages or changes in airflow, it plays a critical role in maintaining proper performance and preventing overheating.
Over time, the pressure sensor can fail due to wear, electrical issues, or buildup of lint and debris. Damage to the sensor or its connections can cause the dryer to operate inefficiently or stop functioning altogether.
Symptoms of a bad pressure sensor include:
- Dryer not heating properly
- Extended drying times
- Error codes related to airflow or pressure
- Dryer shutting off unexpectedly during cycles
This OEM LG part is also compatible with Sears/Kenmore dryers.
More
$21.46
- Compare At:
-
$25.32
- You Save:
-
$3.86
Genuine Whirlpool part
By: Whirlpool
Part Number: W11412300
Fix dishes not cleaning properly or spotty glassware with this dishwasher detergent and rinse aid dispenser. Restores proper soap release timing.
More
$109.73
- Compare At:
-
$131.68
- You Save:
-
$21.95
Genuine Frigidaire part
By: Frigidaire
Part Number: 134629900
Fix a washer that won't start or run because the door won't lock. This door lock assembly secures the door during wash cycles. DIY-friendly repair.
Do-It-Yourself Stories from Customers like You
Washer door lock and latch James J. • Ararat , VA • March 12, 2016
Ordered new parts from appliancepartspris.com
Read more
More
$116.42
- Compare At:
-
$137.38
- You Save:
-
$20.96
Genuine Bosch part
By: Bosch
Part Number: 10010119
Thermister
Do-It-Yourself Stories from Customers like You
Bosch dryer would not start. Roy K. • West Chester , PA • June 12, 2018
After reviewing various posts on the internet, I tested the high heat temperature limiter and determined it was faulty due to lint buildup. Ordered the parts from AppliancePartsPros.com on Friday afternoon and parts were delivered on Saturday afternoon. Replaced the parts- dryer works as good as new.
Read more
More
$37.23
- Compare At:
-
$44.30
- You Save:
-
$7.07
Genuine Whirlpool part
By: Whirlpool
Part Number: 8193646
The Actuator is an OEM part for Whirlpool dishwashers. This actuator is responsible for releasing detergent from the dispenser at the appropriate time during the wash cycle, ensuring effective cleaning of the dishes.
Causes of a bad detergent dispenser actuator can include electrical malfunctions, wear and tear from frequent use, or physical damage to the actuator mechanism.
Symptoms of a bad detergent dispenser actuator include:
- The detergent not dispensing during the wash cycle
- The dispenser door not opening
- Dishes not being cleaned properly due to no detergent release
- Error codes related to the dispenser
This OEM Whirlpool part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper and some Kenmore models.
Do-It-Yourself Stories from Customers like You
Latch would not open consistently on detergent dispenser James G. • Waxhaw , NC • January 12, 2015
Appeared to be two problems: the latch was worn and one of the pins that slid in a guide on the actuator located in the inner panel had broke off. Detergent lid spring and pin appeared to be OK but decided to replace since I was aready working on it. I ordered all the inner panel mechanism from the control arm to the latch actuator on the inner panel. The repair was successful as the detergent dispenser now opens during its cycle.
Read more
More
$54.25
- Compare At:
-
$64.56
- You Save:
-
$10.31
Genuine Whirlpool part
By: Whirlpool
Part Number: W10814230
Cam that engages the lid switch when the washer lid closes, enabling the washer to operate. If your washer won't start or stops mid-cycle, this cam may be worn or broken.
Do-It-Yourself Stories from Customers like You
Lid switch was not turning on, washer filled but didn't wash spin etc George J. • Hopewell , IL • March 02, 2020
I replaced the switch, the plunger, plunger guide and the lid cam, but the cam still didn't turn on the switch. Turned out someone had stood on the washer and bent the lid slightly, not enough to notice, but since I had ruled out just about everything else I started looking at the lid itself. I ended up bending it back close to it's original shape and now it works fine. I guess I learned a few things about washing machines though. One lesson is when you pull off the controls, the hose leading...
Read more
More
$9.63
- Compare At:
-
$11.56
- You Save:
-
$1.93
Genuine Whirlpool part
By: Whirlpool
Part Number: WP3403607
Fix a dryer that won't heat or shuts off after 10-15 minutes with this thermal cutoff fuse. Common DIY repair for temperature detection issues.
Do-It-Yourself Stories from Customers like You
Dryer would run but wouldn't heat Todd B. • Dummerston , VT • August 14, 2016
I replaced the thermal cut-off sensors and the cutoff-Tml
Read more
More
$36.95
- Compare At:
-
$44.34
- You Save:
-
$7.39