Bath Fan Heating Element Parts

• Too warm
• Frost buildup
• Fridge too warm
• Freezer not defrosting

I unplugged the fridge and took all the food and shelving out of the freezer and then proceeded to take off the bottom sliding drawer rack on both sides off (4 Phillips head screws). Then took off the light bulb cover and then the light bulb. Then the back wall that covers the coils and tubes that the refrigerant runs through ( 2 screws with hex head). After sliding out the back wall I could see that the entire coil area was frosted and iced up. I took a blow dryer and melted all of it over... Read more

I followed the directions on several websites for repairs. The obvious place to start is the heating coil and thermostat. I checked the continuity of the coil and it was good with a reading of almost zero resistance. Next I read that there is no thermostat controls on my GE dishwasher so I followed another webpage that said the Sensor Turbidity Assembly acts like a thermostat so I replaced that. Wasted effort as that switch sensor was OK. Normally it has a light on when it is working, a... Read more

• Little to no heat when baking
• Oven not heating evenly
• Oven is too hot
• Won't start

My wife was using the oven and she shouted "emergency, oven fire" as i was half asleep in the reclining chair (I will be 86 in Oct.) As I dashed, well not quite, into the kitchen mentioning the fire extinguisher, she exclaimed "no, electrical fire, throw the circuit breaker"....which I very promptly did and the fire was no more; just a lot of bad odor. Removing the severed 32 year old bake oven element was somewhat delayed due to corrosion of the element mounting screws and electrical... Read more

• Oven is too hot
• Little to no heat when baking
• Oven not heating evenly
• Element will not heat

I cannot not sing the praises of this company & their helpful & fast service. I am going to post the online site address w/my praises on my facebook page for my friends that live on ranches many miles from appliance repair shops & towns. The Oven in our house is for sure over 20 yrs old it was in this home when we bought it, the home is 33 yrs old & the Oven is a Wall Oven, there is not room for a standard Oven in this Kitchen. The Oven itself still looks very nice. About 8 yrs ago or more... Read more

• Little to no heat when baking
• Oven not heating evenly
• Won't start

Replaced lower and upper element. Internet research suggested it was the control board. Thankfully it was a much quicker and cheaper fix. Read more

Two screws in the front, lifted top, removed old burner, replaced with new one. The trickiest part was getting the wires connections loose from the old burner. Read more

• Will not tumble
• Takes too long to dry
• Noisy

I FOUND the website on t internet, found my part ordered it and watched the how to video ,repaired the dryer myself. Awesome Website. Read more

Followed the Appliance Parts Pros video and it took me about an hour from start to finish. I felt like the job was easy to accomplish. Read more

I just googled the error code saw how to do the repair and bought the part. It all went much smoother than I thought. Would do again Read more

Ordered part, reviewed several videos demonstrating replacement of burner. Read more

• Oven not heating evenly
• Little to no heat when baking
• Element will not heat

I began by turning off the breaker. I then removed the screws securing the bake element. I immediately noticed only one side was wired and the other side was burned off. The wire for the burned off section had fallen through the hole in the back of the oven. I tried fishing it out to no avail. I removed two side trim screws, the side trim pieces, and two screws holding the built-in oven into the wall. I was able to slide the oven out and onto a square stool that was the correct height. I... Read more

• No heat or not enough heat

My 12 year old Frigidaire stack on top dryer had been beeping distress messages in some unintelligible code for about a year when it completely stopped producing heat. It also had a long standing issue with delicate fabrics and thin straps or drawstrings getting caught in the drum. After using this site to troubleshoot and viewing the useful how-to videos, I ordered and replaced the heating element, thermal limiter, and felt seals. Based on others' stories, I decided to also replace the rear... Read more

• Little to no heat when broiling
• Oven not heating evenly
• Won't start
• Element will not heat

I cannot not sing the praises of this company & their helpful & fast service. I am going to post the online site address w/my praises on my facebook page for my friends that live on ranches many miles from appliance repair shops & towns. The Oven in our house is for sure over 20 yrs old it was in this home when we bought it, the home is 33 yrs old & the Oven is a Wall Oven, there is not room for a standard Oven in this Kitchen. The Oven itself still looks very nice. About 8 yrs ago or more... Read more

• Element will not heat

I went to a local stove parts store to find a replacement. The store ordered the element for me and promised that it would arrive the next day. I waited for seven 'working' days,but the part never came. So I went online, and found the part in AppliancePartsPros.com. I ordered it in the evening of November 5, 2014, and the part was delivered the next day, November 6 at 11.08AM! Fantastic! I don't know how they could deliver that fast. But clearly, nobody could beat that service. The part fits... Read more

Top mounted freezer with bottom refrigerator. Kenmore Elite Shut off the power Remove all food stuff from freezer (placed in ice chest) then shelves. Removed the ice maker, (easy!) 3 screws and unplugged wires. 2 screws in the back panel. Pulled top forward - downward Unplugged wiring harness from back wall of freezer, removed ground wire from panel Pulled fan blade off. (Fan was attached to back wall, not removable back panel) Removed 2 screws to get to fan motor. 'Unsnapped ' motor... Read more

• Little to no heat when baking
• Oven not heating evenly
• Oven is too hot
• Won't start

Took out old element,got part number and look for the cheapest price online, Appliance Parts Pro could not be beat... order part be number, easy to match, came in fast and put in element, only needed a 5/16 nutdriver to take it out and put it in,unpluged wires and bent just a little to keep one on left and one right from getting mixed up and pluged up new element and ran in the 2 screws,easy job, dont get no easier.. Thanks again Appliance Parts Pro Read more