Power Small Engine Safety Switch Parts
Genuine Frigidaire part
By: Frigidaire
Part Number: 240505801
Fix a refrigerator light that won't turn on or off when the door opens or closes. This door-activated light switch is a simple 5-minute DIY repair.
Do-It-Yourself Stories from Customers like You
Broken ice dispenser actuator, rusty front plate, bad fridge door switch Michael A. • Garnerville , NY • August 06, 2020
My problem started with a rusting condition in the ice bin that spiraled out of hand. I took apart the ice bin and all the hardware thinking I could clean it with the suggested baking powder. Plastic parts cleaned up like new, metal parts were pitted. I wire brushed and sanded the parts put it all back together and gave it a try. All appeared fine then two days later the ice dispenser stopped. I watched a couple of videos and most pointed to the ice auger motor. One video specifically said you...
Read more
More
$64.95
- Compare At:
-
$77.29
- You Save:
-
$12.34
Genuine Whirlpool part
By: Whirlpool
Part Number: WP3391902
Dryer won't start or keeps running with door open? A faulty door switch prevents proper start/stop control. Easy DIY fix in under 30 minutes restores safety.
Do-It-Yourself Stories from Customers like You
Stacked washer/dryer dryer light stayed on when door closed and dryer would not turn on. 25 years old Neal Jay M. • Portland , OR • June 12, 2019
Order part and removed 3 hex head screws at top front edge of dryer and slightly lifted up on control panel to lift off pane. It has hangers that support panel while servicing. Remove 2 screws at inside top edge of dryer opening (where lever of switch protrudes) disconnect 3 wire clips at old switch and restore wire clips at new switch and place switch into position and restore 2 screws to secure switch body.
Read more
More
$52.68
- Compare At:
-
$62.69
- You Save:
-
$10.01
Genuine Whirlpool part
By: Whirlpool
Part Number: W10853313
Genuine Whirlpool OEM moisture sensor bar for electric and gas dryers. Works with a second sensor strip to detect humity/moisture as clothes tumble past. The control board reads the signal to determine remaining moisture and ends the cycle automatically at the target dryness level — preventing over-drying and reducing energy use.
Common Failures
- Cycle ends too soon — clothes still damp
- Dryer won't shut off — runs continuously
- Error codes F:22 or F:26
- Inconsistent results — unpredictable dryness
- Bent, cracked, or detached bar
- Corrosion from dryer sheet chemicals
Do-It-Yourself Stories from Customers like You
The dryer sensor failure. Jim W. • Yukon , OK • January 08, 2024
Purchased a new sensor from AppliancePartsPros.com. Installed new part - Problem fixed.
Read more
More
$50.57
- Compare At:
-
$60.18
- You Save:
-
$9.61
Genuine Whirlpool part
By: Whirlpool
Part Number: W11685945
The Dispenser Switch is an OEM component for Whirlpool washing machines. Located inside the detergent compartment, it detects when the door is properly closed to enable cycle functions.
The sensitive switch utilizes durable contacts to reliably connect without false readings due to vibration. Its secure plastic housing contains electronic components regulating additive distribution during selected cycles.
Symptoms of a bad dispenser switch can include:
- Inability to start cycles despite closed door
- Dispenser door fails to lock properly
- Fault codes relating to dispenser issues
- Cycles unexpectedly terminating mid-load
Replace yours today with this genuine Whirlpool switch to ensure detergent and other additives activate at optimal times for thorough, even cleaning. Compatible with Kenmore, Maytag, and some Jenn-Air washers.
More
$78.78
- Compare At:
-
$93.75
- You Save:
-
$14.97
Genuine Whirlpool part
By: Whirlpool
Part Number: WPW10330137
The Push Button Switch is an OEM part for Whirlpool washing machines. This part activates various functions and cycles on the control panel of the washer. The switch is designed to ensure responsive and reliable operation when selecting wash settings.
Causes of a bad push button switch can include wear and tear from frequent use, exposure to moisture, or physical damage from impacts.
Symptoms of a bad push button switch include:
- Unresponsive buttons on the control panel
- Inability to start or change wash cycles
- Intermittent operation of washer functions
- Error codes related to control panel issues
This OEM Whirlpool part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper and some Kenmore models.
Do-It-Yourself Stories from Customers like You
Dryer was humming when pushing start button Chris K. • N. Wildwood , NJ • May 28, 2017
Removed front of dryer panel, removed top, and removed drum. Replaced motor and wheel, because the old wheel was rusted on the motor shaft, and could not be removed, so I had to break it off. Replaced motor, and reassembled. Everything works now. I also replace the switch-Pb, because the start button was getting stuck.
Read more
More
$229.95
- Compare At:
-
$273.64
- You Save:
-
$43.69
Genuine Frigidaire part
By: Frigidaire
Part Number: 316580614
This assembly includes the spark ignition switches and wiring harness that control the igniter circuits on a gas range or cooktop. The switches detect burner position and signal the igniters to spark when a burner knob is turned. Replace this assembly if burners fail to ignite, click continuously without lighting, or if the spark module does not activate consistently.
Do-It-Yourself Stories from Customers like You
The back left burner didn't light and didn't click when turned the knob Oceanna C. • Watsonville , CA • April 07, 2016
My husband and myself didn't agree on which part was the exact problem. He felt it was the valve. I felt it was the ignitor/ orifice. And we both agreed the Harness-Ignitor needed to be replaced. So we ordered all 3, and I'm not sure if in fact all three were needed or not, but now with those parts replaced, the range is working like brand new!! Thanks to all the videos and diagrams on the website we were able to fix it ourselves easily. And the price was cheaper then other websites, also it...
Read more
More
$83.95
- Compare At:
-
$100.74
- You Save:
-
$16.79
Genuine Frigidaire part
By: Frigidaire
Part Number: A00055408
Fixes dishwasher leaking, error code i20, or pump that won't stop running. Monitors water pressure to control wash cycles. DIY-friendly repair.
Do-It-Yourself Stories from Customers like You
Leaking dishwasher. Richard W. • Louisville , KY • April 20, 2020
Replace the pressure switch.
Read more
More
$65.74
- Compare At:
-
$77.57
- You Save:
-
$11.83
Genuine Ge part
By: Ge
Part Number: WB24X10204
This microswitch senses the microwave door position and controls the safety interlock circuits. Replacing a worn switch restores proper start/stop behavior so the oven only runs when the door is fully closed.
- Detects door open/closed status to enable or disable cooking
- Part of the safety interlock system that stops operation if the door opens mid-cycle
- Replace if the switch fails a continuity check or shows heat or terminal damage
What's included: 1 microswitch
- Disconnect power before service; microwave capacitors can retain a dangerous charge
- Note wire positions and move them to the same terminals on the new switch
- Ensure the door latch cleanly actuates the switch; test operation before reassembly
Do-It-Yourself Stories from Customers like You
Stopped working tripped breaker Roberto M. • Pembroke Pines , FL • March 08, 2019
By replacing the switches.
Read more
More
$64.70
- Compare At:
-
$76.99
- You Save:
-
$12.29
Genuine Ge part
By: Ge
Part Number: WE04X25194
Dryer not heating or overheating? This thermostat regulates temperature during the drying cycle. Common DIY repair that restores proper heat control.
Do-It-Yourself Stories from Customers like You
Not getting very hot Gore, R. • Silsbee , TX • November 07, 2025
Did it myself.
Read more
More
$34.56
- Compare At:
-
$41.47
- You Save:
-
$6.91
Genuine Ge part
By: Ge
Part Number: WE4M300
Fix a dryer that won't heat with this outlet backup thermostat. Mounts on exhaust duct for over-temperature protection. DIY repair in under 1 hour.
Do-It-Yourself Stories from Customers like You
Gas dryer was not heating Charles M. • Huron , OH • September 01, 2016
Checked vent first to see if there was a blockage.
Removed top, front and drum of dryer.
Replaced all sensors including flame detection and gas valve coils.
Re-assembled and tested.
Dryer was now heating
Read more
More
$60.35
- Compare At:
-
$72.42
- You Save:
-
$12.07
Genuine Whirlpool part
By: Whirlpool
Part Number: WP503979
Fix a dryer that overheats, won't dry completely, or stops mid-cycle. This cycling thermostat regulates heat to prevent damage. DIY-friendly repair.
Do-It-Yourself Stories from Customers like You
Bad thermal fuse Orville L. • Winneconne , WI • October 02, 2015
I replaced the main parts for the dryer cycle system
Read more
More
$79.95
- Compare At:
-
$94.34
- You Save:
-
$14.39
Genuine Whirlpool part
By: Whirlpool
Part Number: WP74003122
Fix a burner stuck on high or won't adjust temperature with this infinite switch. Controls cooktop burner heat levels. DIY repair in under 30 minutes.
Do-It-Yourself Stories from Customers like You
Element would stay on high even at lower settings why it would fail in the "high" mode is not a good design David M. • Suffield , CT • February 04, 2015
Replaced the Infinite Switch and that solved the problem. Did not need to replace the Surface Element
Read more
More
$61.56
- Compare At:
-
$73.26
- You Save:
-
$11.70
Genuine Frigidaire part
By: Frigidaire
Part Number: 316219004
Fix burners that won't spark or click constantly. This igniter switch wiring harness restores reliable lighting on gas ranges. DIY-friendly repair.
Do-It-Yourself Stories from Customers like You
One of my stove burners would not spark. Mike M. • Bound Brook , NJ • October 26, 2023
I replaced the switch/wire harness that connects to the gas valves.
Read more
More
$128.66
- Compare At:
-
$153.11
- You Save:
-
$24.45
Genuine Frigidaire part
By: Frigidaire
Part Number: 5304527841
The Rocker Switch is an OEM part for Frigidaire ranges and ovens. It is responsible for turning the interior oven light on and off. The light switch allows visibility of the oven cavity for viewing food during the cooking process.
Causes can include normal wear and tear over time, exposure to heat inside the oven cavity, or accidental damage.
Symptoms of a bad oven light rocker switch include:
- The oven light failing to illuminate when the door is opened
- The light remaining on even when the door is closed
- An inconsistent or flickering oven light
- The switch itself becoming loose, cracked, or non-responsive
This OEM Frigidaire part is also compatible with Electrolux, Gibson, Kelvinator and some Kenmore models.
Do-It-Yourself Stories from Customers like You
1 of the 4 burners would not ignite with its own control Shane W. • Fullerton , CA • November 15, 2022
Removed & replaced igniter switch assembly. The hardest part was figuring out how to remove the range top...look up a YouTube video with your manufacturer and model number to see how to do it.
Read more
More
$20.69
- Compare At:
-
$24.83
- You Save:
-
$4.14
Genuine Whirlpool part
By: Whirlpool
Part Number: 8203534
Fix a burner stuck on high or that won't heat properly with this cooktop infinite switch. Restores accurate temperature control. 30-minute DIY repair.
Do-It-Yourself Stories from Customers like You
Failed dual element switch on whirlpool ceramic cooktop model #gjc3034gb0 Rodney S. • Kuttawa , KY • August 17, 2014
This cooktop has a dual element with an inner burner surrounded by an outer burner. The switch controls either the inner burner alone or both. The switch failed in that it would not operate the inner burner by itself, both burners would come on and only on high. On 8/14/2014 I replaced the failed dual element switch as follows:
• Turned power off to cooktop.
• Removed unit from cabinet.
• Removed metal edging and glass top.
• Removed screws holding switch panel access underside.
• Removed old...
Read more
More
$97.77
- Compare At:
-
$115.37
- You Save:
-
$17.60
Genuine Samsung part
By: Samsung
Part Number: DA34-00043B
The Refrigerator Door Switch is an essential component designed to maintain the optimal performance of your Samsung refrigerator. This genuine OEM part features a reliable switch reed mechanism that accurately detects when the refrigerator door is opened or closed. By ensuring the door is properly sealed, it helps regulate the internal temperature, keeping your food fresh and your appliance running efficiently. The Refrigerator Door Switch is compatible with a wide range of Samsung refrigerator models, making it a versatile choice for your repair needs. Installing this switch is straightforward, allowing you to quickly restore your refrigerator's functionality without hassle. Whether your current switch is malfunctioning, causing the door light to stay on, or affecting the cooling performance, the Refrigerator Door Switch provides a dependable solution. Trust in this genuine OEM part to deliver consistent performance and extend the lifespan of your refrigerator, ensuring a reliable and efficient kitchen appliance for years to come.
Do-It-Yourself Stories from Customers like You
When opening the left side door on occasion the light would not come on John F. • Sorrento , FL • February 10, 2019
Replaced the reed switch
Read more
More
$21.05
- Compare At:
-
$23.16
- You Save:
-
$2.11