Clean Incoming Power Problem Parts
Genuine Whirlpool part
By: Whirlpool
Part Number: WP3391912
Dryer won't heat or shuts off early? The high limit thermostat monitors temperature and cuts power when overheating occurs. DIY repair in 30 minutes.
Do-It-Yourself Stories from Customers like You
My maytag gas dryer would start and the the tumbler rotate but the igniter would not glow and flame not start .gil P. • Enumclaw , WA • March 29, 2015
The 2 sensors that sit on top of the flame tube work together. The Thrmst F should check closed, as should the Cutoff-TML, in order for power to flow to the ignitor. If the Cutoff is open, it is usually because the Thrmst-F did not open soon enough. The Thermst-F will cycle, closed to open, and repeat, however the Cutoff-HTML is a one time switch. If it opens it will not return to closed, and subsequently the ignitor will not glow.
Some professionals say that if one of these sensors fail, both...
Read more
More
$60.52
IN STOCK
Most orders arrive by Wednesday, November 25
Genuine Whirlpool part
By: Whirlpool
Part Number: WPW10394053
Secures water filter for proper filtration and flow to dispenser or ice maker. Replace if cracked, leaking, or filter won't seat properly. Verify fit.
Do-It-Yourself Stories from Customers like You
The old water filter was stuck in housing. George L. • Lanham , MD • April 25, 2023
Replaced the old housing with new water filter housing.
Read more
More
$109.41
IN STOCK
Most orders arrive by Wednesday, November 25
Genuine Ge part
By: Ge
Part Number: WR17X22070
Bypass cap allows refrigerator water and ice dispensers to work without a filter installed. Replace if cracked or leaking. Confirm fit with your model.
Do-It-Yourself Stories from Customers like You
12 y o rental unit ge side by side was missing parts and dispenser was non functional Scott M. • Asheville , NC • October 04, 2015
First I ordered a new ice door seal, spring, and crank, figuring the condensation in freezer and door was caused by ice door not sealing. Turns out the solenoid for the ice door was completely rusted and was the primary cause, if it had been replaced early, it would have saved the dispenser board. What then happened was the moisture in the freezer door damaged the control board rendering dispenser controls inoperative as well as the heater around the dispenser. Now the freezer door is dripping...
Read more
More
$14.49
IN STOCK
Most orders arrive by Wednesday, November 25
Genuine Ge part
By: Ge
Part Number: WE04X26216
Dryer not heating properly or overheating? This thermostat regulates temperature to keep your dryer running safely. Simple DIY fix in under an hour.
Do-It-Yourself Stories from Customers like You
Not getting very hot Gore, R. • Silsbee , TX • November 07, 2025
Did it myself.
Read more
More
$36.95
IN STOCK
Most orders arrive by Wednesday, November 25
Genuine Frigidaire part
By: Frigidaire
Part Number: 137116700
This high limit thermostat is a safety device that monitors the temperature inside the dryer and cuts power to the heating element if the temperature exceeds a safe threshold. It is typically mounted on the heating element housing or exhaust duct. Replace this thermostat if the dryer is not heating at all or if it overheats - a tripped high limit thermostat often indicates a clogged vent or restricted airflow that should also be addressed.
Do-It-Yourself Stories from Customers like You
Frigidaire dryer error e66 then door open Nolan R. • Hoboken , NJ • February 06, 2017
My Electrolux Frigidaire Gas Dryer stopped working and I got an error code E66 that the thermal limiter blew from over heating. The E66 code stops displaying after the initial code and you will then get a door open message. I replaced the thermal limiter and the thermostat just to be sure which part at the problem. The job is hard because you have to take apart the entire dryer and remove the drum. Would be a tough project to complete on your own.
Read more
More
$50.56
IN STOCK
Most orders arrive by Wednesday, November 25
Genuine Ge part
By: Ge
Part Number: WR17X22072
This component houses and connects the water filter to the refrigerator's water system, typically located in the base grille or upper right interior. Replace when water leaks around the filter, flow decreases significantly, or the housing cracks.
Do-It-Yourself Stories from Customers like You
Low water pressure and flow from the water dispenser on ge profile refrigerator Alex D. • Sanford , FL • December 22, 2016
The refrigerator is about 8-9 years old. GE Profile side by side with water and ice dispenser in the freezer door. Recently, it was time to replace the MSWF cartridge (the indicator light came on). I've done this numerous times over the years, but on this occasion, after installing the new cartridge, I noticed a significant drop in the water pressure and quantity coming out of the dispenser. The ice maker did not seem to be affected, but the water dispenser was definitely a slow trickle. I...
Read more
More
$73.67
IN STOCK
Most orders arrive by Wednesday, November 25
Genuine Whirlpool part
By: Whirlpool
Part Number: W11395888
Bypass cap replaces water filter when filtration isn't needed. Install when using RO system or preferring unfiltered water. Confirm fit with your model.
Do-It-Yourself Stories from Customers like You
Water dispenser made a lot of noise Pablo C. • Apex , NC • November 23, 2015
Water dispenser came down to a trickle and made a lot of noise, I changed the filter but it didnt help and thus the water tank/head assembly needed to be replaced.
Replacing the water Tank/head assembly was an easy task, the hardest part is removing the covers and taking care of not breaking the insulation of the water inlet hose.
For the not-so-experts like me it is also good to rememebr to have a bucket to collect all the water that comes out after the connection to the solenoid valves is...
Read more
More
$48.46
IN STOCK
Most orders arrive by Wednesday, November 25
Genuine Ge part
By: Ge
Part Number: WE4M216
Dryer won't heat, overheats, or shuts off mid-cycle? A faulty cycling thermostat often causes these issues. Easy DIY fix with our video guide.
Do-It-Yourself Stories from Customers like You
Constant high heat coils did not respond to selector switch heat setting Robert C. • Fairfield , CT • July 23, 2018
Replaced cycling thermostat.
Read more
More
$88.66
IN STOCK
Most orders arrive by Wednesday, November 25
Genuine Samsung part
By: Samsung
Part Number: DA97-17376B
Purifies drinking water and ice in your refrigerator. Replace every 6 months or when flow slows to maintain clean water. Confirm fit with your model.
Do-It-Yourself Stories from Customers like You
Needed a new water filter. Lynda C. • Gainesville , GA • September 21, 2021
Replaced filter.
Read more
More
$53.21
IN STOCK
Most orders arrive by Wednesday, November 25
Genuine Lg part
By: Lg
Part Number: ABN73019101
Allows water to flow directly to your dispenser and ice maker without filtration. Install when choosing not to use a water filter. Confirm fit by model.
Do-It-Yourself Stories from Customers like You
No problem did not want filter for filtered water Rahul P. • Anaheim , CA • November 06, 2017
Replaced filter with plug.
Read more
More
$24.68
IN STOCK
Most orders arrive by Wednesday, November 25
Genuine Whirlpool part
By: Whirlpool
Part Number: WP306604
Dryer won't heat or start? This thermal fuse cuts power when temperatures get too high. Test with a multimeter for continuity. Easy DIY repair.
This part fixes the following symptoms
-
Won't start
-
No heat or not enough heat
See more...
Do-It-Yourself Stories from Customers like You
Maytag gas dryer was not heating Christopher P. • Los Angeles , CA • October 04, 2014
Did some dryer repair research (dryer not heating) on the internet. Bought an ohm meter, opened up the dryer and tested the cut-off-T, high limit thermostat, dryer igniter, flame sensor, cycling thermostat for continuity. The igniter was bad, the other parts tested ok. Went online to AppliancePartsPros.com searched for a new igniter for my specific dryer model, found the right replacement igniter and watched the video on how to replace the igniter. Because my dryer is old (15+ years) and I...
Read more
More
$29.48
IN STOCK
Most orders arrive by Wednesday, November 25
Genuine Ge part
By: Ge
Part Number: WE04X20685
The Thermistor is an OEM replacement part for GE dryers. This temperature-sensing device monitors air exhaust temperatures and communicates real-time readings to the control board. Precise thermistor functioning ensures the heating elements and drum engage safely and appropriately.
Symptoms of a faulty thermistor include:
- Slow or inconsistent drying times
- Excessive heat inside the dryer chamber
- Overheating indicator lights illuminated
- Potential shut-offs due to high-limit temperature triggers
Causes often relate to moisture exposure from normal operation degrading electronic performance over time. Physical stress or impact could potentially damage thin connecting wires.
This GE replacement part is also compatible with Hotpoint, RCA, and some Kenmore dryers.
Do-It-Yourself Stories from Customers like You
Gas dryer was not heating Charles M. • Huron , OH • September 01, 2016
Checked vent first to see if there was a blockage.
Removed top, front and drum of dryer.
Replaced all sensors including flame detection and gas valve coils.
Re-assembled and tested.
Dryer was now heating
Read more
More
$18.76
IN STOCK
Most orders arrive by Wednesday, November 25
Genuine Ge part
By: Ge
Part Number: WE04X25200
Dryer not heating or drying clothes properly? This cycling thermostat regulates temperature during the drying cycle. Moderate DIY repair for most models.
Do-It-Yourself Stories from Customers like You
Failing to dry clothes David K. • Mohnton , PA • September 19, 2022
Removed exterior panels, cleaned all venting, replaced outlet thermistor and thermostat. Pressure washed all removable parts. Reassembled. Now working as it should.
Read more
More
$18.95
IN STOCK
Most orders arrive by Wednesday, November 25
Genuine Frigidaire part
By: Frigidaire
Part Number: 240396002
Secures the water filter and connects it to the supply line. Replace if your filter leaks, pops out, or won't stay seated. Verify fit with your model number.
This part fixes the following symptoms
-
Leaking
-
Not dispensing water
See more...
Do-It-Yourself Stories from Customers like You
Frigidaire puresource2 water filter kept popping out Larry G. • Tacoma , WA • October 18, 2014
Turned off water behind the fridge. Unscrewed housing that covered water lines behind the filter base with a 1/4" socket. Pulled out the water hoses by pulling forward on the blue ring holding the hose while pulling the hose backward. Unscrewed the two screws below the filter base. Used the 1/4" socket to remove four additional 1/4" nuts holding the front housing until it partially dropped. I kept the housing propped on a jar. Unscrewed two additional screws holding the filter release rod in...
Read more
More
$91.95
IN STOCK
Most orders arrive by Wednesday, November 25
Genuine Whirlpool part
By: Whirlpool
Part Number: WPW10121140
Encloses the water filter to ensure proper flow and filtration. Replace if cracked, leaking when filter is removed, or causing water hammer. Confirm fit.
Do-It-Yourself Stories from Customers like You
New filters would cause the water lines to "hammer" and/or no flow; valve internal to the housing was stuck open so water flowed onto the floor when the filter was removed Michael G. • Mcmurray , PA • August 30, 2021
The video was very helpful, but my KitchenAid model required slightly more steps. Only the two screws in front held the filter housing, same as the video shows, but it has to be removed from the rear. My model did not have the wire brace, only the two front screws held the housing. Shut the water off and pull the electrical plug. Remove the two screws holding the filter housing in the front. Remove the lower panel in the rear at the bottom of the refrigerator. Remove the two screws holding the...
Read more
More
$130.50
IN STOCK
Most orders arrive by Wednesday, November 25
Genuine Ge part
By: Ge
Part Number: WR01X29059
Water filter bypass plug allows your refrigerator to operate without a filter by creating direct water flow. Replace if damaged or worn. Confirm fit with your model.
Do-It-Yourself Stories from Customers like You
Needed bypass for the water filter. Mary Aka Maria D. • Las Vegas , NV • June 09, 2020
Ordered a bypass and installed it.
Read more
More
$46.95
IN STOCK
Most orders arrive by Wednesday, November 25