Electrolux Duty Moisture Sensor Bags Parts

• Freezer not defrosting
• Too warm
• Fridge too warm
• Freezer section too warm

I ordered a freezer temperature control. I ordered from you because parts are certified. Last thing I wanted was to go through the replacement process with a part that didn’t work. I’m not a handy person by nature, and I have zero common sense. I watched the awesome instructional video that you provided with my order several times. Before receiving or even opening the package, I felt that I knew what to expect because I watched the video so many times. Before beginning, I made sure I had as... Read more

• Oven is too hot
• Oven not heating evenly
• Little to no heat when baking
• Won't start

Bought a used Frigidaire 36 inch stove. The broiler didn't come on but the burners lit and the stove worked so I made do for about 4 or 5 years with that. Then the F10 code came up and it wouldn't stop beeping until I unplugged it. I figured the electronics/circuit board was probably bad and ordered a replacement. I was confused about what part to order. The parts list includes "Control Panel" and "Clock - Timer". Turns out the control panels are the glass panel on the front of the stove... Read more

• Too warm
• Doesn't shut off
• Fridge runs too long
• Freezer not defrosting

Fixed it by replacing the electronic control board. Only 30 min. to fix. (See further down for effort to diagnose the problem.) Most of this "fixing time" was spent removing the control panel to access the control board that is attached to it. My freezer has the control panel located in the top center of the door. The only way to remove the control panel is to pry the panel out of the door using a thin-bladed putty knife.The instructions provided were very good in explaining the process;... Read more

• Shuts off too soon
• Too hot
• Takes too long to dry
• No heat or not enough heat

My appliance repair guy checked out the problem, but the stack washer dryer required the contractor to dismantle the cabinet to allow the repair to occur. So i wanted the parts available for the repair, so we would not have to have the dryer pulled apart in a small space for an extended time i ordered the parts on Friday afternoon and they arrived at my home before noon on Saturday! The contractor and the repairman were able to coordinate the repair on Tuesday morning, and though the... Read more

• Shuts off too soon
• Too hot
• Takes too long to dry
• Won't start

Recommendations have fun and a bucket to prevent losing parts. First watch the videos, practice disassemble and reassemble the dryer drum. Make certain you have a good screw driver and spatula from kitchen (could not find my putty knife). Secondly, clean and inspect everything, make sure the motor bearing and belt pulleys are in good condition with little or no play. Third after you have confidently disassembled, vacuum cleaned, inspected all the worn parts, grease the motor and pulley,... Read more

I think I have a lemon of a dryer. I keep having to pay someone to replace my heating element about every year. So I already had the heating element, but I thought I would replace the thermostat and the limiter also. Yes, I am a 46 year old mom, and I replaced all three items. Thank goodness to youtube! Ha! I have ordered from you before and you always send promptly. Thanks! Read more

Walk into the kitchen on 21 Sep. Eight year old Frigidaire refrigerator appears to be short cycling, controls are nonfunctional. Unplug it for a few minutes, plug it back in, appears to return to normal function. Return to kitchen half hour 45 minutes later it's short cycling again. Panel has codes on it (S or 5 E CE, later that changes to S or 5 Y CE). Research of codes says replace main board and control board. Not sure where this main board is. 22 Sep call appliance repair. "Soonest... Read more

Replaced control board. Did not need Control Thermistor in my case, but I'm keeping it as backup. Got the Drum Belt just in case it breaks on me since the dryer is aging. To replace control board: Disconnect power and pull dryer away from wall. Take 2 black screws on the back off to remove the top lid. Remove 2 screws on top that hold the control interface on. Remove 2 screws on the bottom backside of the control. Pull out control panel and pull off terminal connections and push to remove... Read more

Replaced exhaust thermal cutoff switch. Sears wanted to charge for a service visit + parts and labor. $17 part, $6 shipping and I received the part the following day. Repair complete in less than an hour at a fraction of the cost. Thanks appliance pros. Read more

• No heat or not enough heat

Being a complete DIY I hate to call some unknown person into my home knowing that just to get them there will cost me more than I will spend for parts that I don't need.After all, they are trying to make a living and by selling me parts that I don't need will increase their profits. I've dealt with APP before and was impressed by their site because I could find both mechanical and electrical drawings for almost everything I have. I looked up my dryer, decided what was probably the problem,... Read more

After doing some research the problem appeared to be the door safety switches. I ordered 3 new ones to replace all the original ones. Some minor disassembly of the microwave front was required to reach the fuse and switches. To reach the switches the control panel wires needed to be unplugged and the panel removed. After doing that replacing the switches was pretty strait forward. As of this comment the microwave has worked for 5 days without blowing the fuse so far. This has probably fixed the... Read more

REPLACED DEFROSTER, CONDENSER FAN MOTOR AND DEFROST THERMOSTAT. Read more

Checked compressor windings - ok. Start relay looked no rattle or burning. Start capacitor seamed ok but hard to check. No 120VC to start relay at any time. Ordered thermistor, and electronic control unit. Figuring it was a bad thermistor not telling the ECU it was warm and to turn on the compressor. Or the ECU was damaged and was not sending the 120v to the compressor. Changed the thermistor first (cheapest part and as Appliance parts pros has a return policy I wanted to start there). ... Read more

Checked compressor windings - ok. Start relay looked no rattle or burning. Start capacitor seamed ok but hard to check. No 120VC to start relay at any time. Ordered thermistor, and electronic control unit. Figuring it was a bad thermistor not telling the ECU it was warm and to turn on the compressor. Or the ECU was damaged and was not sending the 120v to the compressor. Changed the thermistor first (cheapest part and as Appliance parts pros has a return policy I wanted to start there). ... Read more

I defrosted the evaporator coil and replaced the defroster element and thermostat. Read more

I actually found a post from another brave soul who was willing to try to fix his, and had stated when he put the new limiter switch in, it fixed the problem. Since the whole back of the dryer needs to come off to get to the burner, and the limiter switch is inexpensive it seemed like common sense to take this approach first. After all, you don't put a new engine in your car if all it needs is a new battery! I also found posts that an overheating event could fry the main control board, and... Read more