Kbrs22kgbl00 Parts

I have a Jennair jjw9630cas double wall oven, and after a few years I noticed that the light would not go out, first in the bottom oven, and then in the top oven. After doing some research I discovered this was not uncommon, and the fix usually involved replacing the hinges and/or the hinge receptacles. It didn't look like a difficult fix so I ordered four new hinges and four new receptacles, which arrived quickly. I found a video on YouTube that showed how to replace the hinges and it... Read more

Replaced door switch - it took less than 5 minutes - works perfectly Read more

• Door won't open or close
• Door sweating
• Frost buildup
• Leaking

I followed a video to remove the inside door panel and gasket. Putting the new gasket was as easy as the video said. The only problem was ice had built up on the inside of the door panel that needed to be defrosted. Read more

Replaced It With New One Read more

Touch up paint Read more

• Freezer not defrosting
• Too warm
• Fridge runs too long
• Fridge too warm

I am not new to APP, fixed a tub belt on a Maytag dryer in the past. My frig started getting warm so I went onto to one of those "lists" sites and found a appliance repair place. The guys were great and came out right away. The tech said it was the cold control and $260 later my part was replaced, about 30 minutes. Great I thought until my frig started getting warm again. Those cold sensors on the beer bottles are a great indicator. Not wanting to spend another $260 I looked up on APP to see if... Read more

• Freezer not defrosting
• Frost buildup
• Fridge too warm
• Fridge runs too long

I am not new to APP, fixed a tub belt on a Maytag dryer in the past. My frig started getting warm so I went onto to one of those "lists" sites and found a appliance repair place. The guys were great and came out right away. The tech said it was the cold control and $260 later my part was replaced, about 30 minutes. Great I thought until my frig started getting warm again. Those cold sensors on the beer bottles are a great indicator. Not wanting to spend another $260 I looked up on APP to see if... Read more

I can't believe that we lived with this shelf bar continually falling off for years due to a broken end cap. Easily found the replacement end cap on AppliancePartsPros for our 18 year old refrigerator. The "repair", if you can call it that, took perhaps 30 seconds -- remove old broken end cap, insert new one. Done. No more shelf bar falling off. One of life's little annoyances just went away. Read more

• Fridge too warm

Unfortunately, this model has the screws that you need to loosen before you can squeeze the rubber in but the gaskets fit perfectly. It took a lot more time than the video showed but that was because the video was of the pop in type. Be sure when pushing the rubber under the metal strip you make sure it actually goes in. I think the last people installed the gaskets incorrectly and that's why they broke and pulled out of place. Unscrew the bolts first, I used an electric drill. The old gasket... Read more

• Freezer section too warm

I ordered the replacement gasket and...replaced it. One issue was that the replacement procedure was not at all like the video to which I was directed when I got the gasket. The video showed a gasket with a rigid flange that had to be inserted into the door structure. On my Amana, I clearly had to remove the inner plastic liner and set the gasket under it. This was not particularly difficult but certainly wasn't the same process. Also, I removed the freezer door to do the replacement in... Read more

Maytag Dishwasher (about 5 years old). Some of the buttons had stopped functioning. Then the Start button began choosing whether or not to work. Eventually it would not start at all. Upon removing the control panel, the first thing I noticed was that the brackets that hold the two lower screws were broken. (So this was the reason that the door was so hard to open from the time it was new.) I trouble shot the thermal fuse, the door-latch switches, and inspected the control board trying to find... Read more

• Freezer section too warm
• Won't start

After running some tests I determined that the problem was a bad defrost timer. The timer would occasionally fail to trigger the compressor to restart at the end of the defrost cycle. Since I had the unit taken apart, I replaced the termination t-stat and the compressor start relay at the same time. Parts came quick 1.5 days, job completed and the unit is up and running. Read more

• Ice maker not making ice

We had a sears tech come out and "inspect" our freezer - he said it was one of the 2 vales behind the fridge that needed to be replaced. I found them for 50 bucks each on amazon... but then I thought I might shop around. Then i found this kit - that has the 2 valves AND the icemaker assembly for basically the same price. I went ahead and swapped out the icemaker assembly since it didn't involve getting behind the fridge. the next morning - BOOM ice. lots of ice. amazed. and happy. Read more

Tested start relay and fan with multimeter both passed. The condenser would start only if the thermostat was on the highest setting and the refrigerator would cool for a while, stop and not restart unless I adjusted the defrost timer. Decided to replace the thermostat, defrost timer and defrost thermostat. The refrigerator is working as expected. FYI on a Kenmore 59669142992 the defrost timer is located under the freezer in the front right. Read more

• Ice maker won't dispense ice
• Ice maker not making ice
• Leaking

After some research on the internet,I found out that the most likely cause was a failed water inlet valve. The refrigerator is quite old so I wasn't going to spend an arm and leg on it to fix it. I was pleasantly surprised to find the part, at a reasonable price, that I needed on this website with a helpful how-to video to boot. The part I needed wasn't in stock. I was followed up with an e-mail stating an estimated time when the part would be released. A week or so later I received the... Read more

• Noisy

Used Google to troubleshoot the issue. Inside the freezer I took the back off. Noticed two things. The evaporator motor was not turning and the top half of the coils were frozen over. Obvious fan not spinning issue. I felt the motor and it was hot. Spun the fan it it started spinning. Put it all back together. Ran OK for 5-6 more days then same issue. I ordered the new motor and then and spun the fan again. It lasted for 2 days. Had to spin the fan to get it going 2 more times until... Read more