Need Help?
Call or text
Some parts shown may not be for your model. To see parts for your model only, select it from "Matching Model Numbers" list on the left.
Microwave not heating food? A faulty high voltage diode disrupts power conversion. Common DIY repair requiring discharge safety and multimeter testing.
After dismounting the unit from its wall-hanging bracket, the most tedious part of the repair was removing over a dozen screws holding the cover in place from the top, bottom, and both sides. Fortunately, I had placed the unit on a bench that allowed me to slide the unit allowing access to the screws on the bottom edges of the unit. Always discharge the capacitor before continuing to work on the unit by discharging the capacitor by shorting the contact without the diode to ground. Access to the... Read more
The Microwave Door Switch is essential for maintaining the safety and functionality of your Samsung microwave. This genuine OEM part is specifically designed to replace faulty door switches, ensuring your appliance operates correctly. With its precise en
Checked the three door switches; used ohm meter to see if there was resistance or if a switch was bad. 2 out of 3 switches showed resistance with the ohm meter. The last one tested (of course the last one) NO (normally open) did not show resistance; I.e. the ohm meter reading did not change when the switch was depressed. Appliance parts pros was the only company that had the same model number I was looking for (SZW-V16-FD-63). I ordered the relay switch, 2 days later it arrived (regular... Read more
Illuminates appliance interior. Replace when burned out or dimming. Verify wattage and base type match your model before ordering. Easy DIY fix.
Dropped light panel by removing two screws with socket set. Unplugged two terminals and unclipped the light socket from the base. Then just clipped the new socket onto the base, plugged the connectors onto the terminals and remounted the base. Total job was less than 15 minutes. Read more
Fix a microwave that runs but won't heat or won't start when door closes. This door switch is a common fix—most DIYers replace it in 15 minutes.
Fix a microwave that runs but won't heat with this high voltage diode. Converts AC to DC power for proper heating. Typical DIY repair in under 2 hours.
I am not an appliance repair man. I am a general surgeon. I went online and researched the problem. The consensus was that my magnetron and diode were the most likely culprits. To replace my microwave with a comparable model would have cost at least $800. The diode and magnetron cost around $170. I watched a few videos on YouTube demonstrating how to do the repair safely and I felt like I could do it. I ordered the parts on a Monday evening and had them Wednesday. The only difficult part of... Read more
Microwave won't start or runs only when door is pulled? Replace faulty door interlock switches. This 2-pack covers top and bottom switches. DIY repair.
First, it was going to cost $95 for an appliance guy just to look at it! I figured there would be an upcharge on the parts + labor on top of the $95, so I took a chance & decided my husband & I could fix it cheaper; we were right, but it was a 3 week process (luckily, we have another microwave in the basement we were able to use in the meantime). I googled the microwave model #, then price checked the same item I thought we needed; printed off the diagrams of the various microwave "systems" &... Read more
Microwave won't turn on or has no power? A blown fuse is often the cause. This safety component protects against electrical surges and short circuits.
I have a Jenn-Air microwave that didn't turn on and had no lights. It just stopped working completely. I unplugged the unit and had to remove the rear cover using a *security screw kit* that prevents people from opening the rear panel. Once opened, I removed the fuse and testing it with an OHM reader to determine that the fuse went bad. But I also had to determine why the fuse blew and noticed a sticky oily substance under the Capacitor. I used a rubber glove and needle nose pliers to... Read more
This 8-18 x 5/8-inch screw secures dryer panels, brackets, and covers. Replace missing or stripped fasteners to restore a tight fit and stability.
I put all pieces that I ordered on the dryer and plugged it in. Read more
The Screw is an OEM part for Whirlpool appliances. This specific screw is used in various locations within Whirlpool appliances, securing components and ensuring the stability and proper alignment of parts. It is designed to fit precisely and maintain
I replaced all three baffles since the new one was a different design than then old one. i watched the video and the repair went well, except for hitting my hand with a hammer while removing the old baffles. went just like the video said it would Read more
Microwave not heating but still running? The magnetron controls heating function. DIY repair in under 2 hours with basic tools and multimeter testing.
This door interlock microswitch detects when the microwave door is fully closed and allows the unit to run only under safe conditions. Replacing a worn switch restores reliable starting and consistent operation tied to the door latch.
Utilized a YouTube video to isolate the door switches as the issue. These were easily identified following the isolation process and simple testing. I ordered a door switch and secondary switch on Monday and they arrived on Tuesday via FedEx. 15 Minutes to re-install, re-assemble cover and the unit was working fine. A very good experience with parts availability and shipping. Read more
Restores interior lighting in your microwave oven. Replace when bulb burns out to regain visibility while cooking. Verify fit using your model number.
Ordered and recieved new bulb, called help desk to find how to access the bulb. Found I needed a tamper proof torx bit to remove cabinet screws. After buying bit the job was a snap! Thanks to Appliance Pro. comm and their 24 hr. help line Read more
The Microwave Gas Sensor is a vital component for maintaining the safety and efficiency of your microwave. This genuine OEM part is specifically designed to work seamlessly with Samsung microwave models, ensuring a perfect fit and optimal performance. Th
Unplugged power cord. Removed the microwave from over the range. Removed vent and screws on of microwave, which allowed me to remove compartment containing sensor at upper left area of microwave. Removed clamp holding sensor. Removed and replaced sensor. Reversed process and reinstalled unit. Read more
Supports and guides the glass turntable for smooth rotation and even heating. Replace when tray wobbles, stalls, or makes scraping noises. Confirm fit.
All you had to do was open the microwave door and take out the tray and put down the ring and put the tray back in. Read more
Microwave won't turn on or has no power? A blown fuse is often the cause. This safety fuse protects circuits from shorts. Requires cover removal to replace.
In addition to blown fuse; the fuse holder was melted at one end. Checked the unit to see if any part or wiring that would cause the issue, none was visible. Referred to wiring diagram included inside to identify components, including interlocks. All seemed functional. Bought replacement 20A fuse. Fuse holder no longer available so bought similar unit with 25A rating - little retrofitting. Put unit back together, and it's working so far. Wife is happy. Read more
The Screw is an OEM part for Whirlpool microwaves. It is responsible for securing various parts of the microwave together. This screw ensures a tight and secure fit for parts and helps maintain the structural integrity of the microwave, preventing any
I received the parts from parts pro within 3 days and everything fit perfectly nd all went well Thanks Parts Pro Wayne Mazur Joliet Il Read more