Need Help?
Call
Some parts shown may not be for your model. To see parts for your model only, select it from "Matching Model Numbers" list on the left.
This gray magnetic door gasket seals the fresh food compartment door on the refrigerator, preventing warm air from entering and cold air from escaping. It attaches around the perimeter of the door and uses embedded magnets to hold a tight seal when closed. Replace this gasket if you notice condensation forming around the door, frost buildup inside the compartment, or if the refrigerator is running more frequently than normal due to air leaks.
NOTE: Can be used for Right or Left Side.
I bought new gaskets, which were expensive! At least the repair was easy. Pulled out the old ones, pressed in the new ones. Had to redo them because I didn't notice the little flaps that need to be covering the space in the middle, between the doors. So, pulled them off, and turned them around, and pressed them on again. Maybe 10 minutes? Read more
Center support rail that guides and stabilizes crisper drawers as they slide. Replace if cracked, broken, or missing tabs prevent smooth drawer operation.
I ordered a replacement part...took the shelf out of the refrigerator and slid the new rail into place. It was quick, required no tools and it works perfectly! Read more
Replace your refrigerator water filter every 6 months to ensure clean, fresh-tasting water and ice. Easy twist-on installation. Verify fit with your model.
Ordered part and replaced it Read more
Guides condensation from the defrost cycle to the evaporation pan. Replace if cracked, clogged, or causing water leaks and ice buildup in the freezer.
The drain tube for for the defrost cycle seemed to be blocked, so I googled the repair & it sent me to AppliancePartsPros. Obviously, there's a design problem with this model since many other people have the same issue. This tube is an upgrade on the original for my KitchenAid model (design flaw). Since installation 4 days ago, I have had no leaks - awesome! The video for installation of the new tube on AppliancePartsPros was excellent. Two additions to the video: 1) I used a hair dryer... Read more
Interior lights staying on or not working? This door switch controls refrigerator lighting and functions. Moderate DIY repair with video guide available.
I watched the video on replacing the switch on a side freezer where prying out to original switch did not look difficult. I then got on the floor and tried to pry out my switch. Had a terrible time (locking tab or switch body hardened with time?) and mangled the switch terribly and the upper panel of the freezer somewhat, but the switch did come out. AND THEN the top freezer panel with the switch and light assembly fell out into my hands! I was able to unplug one Molex connector and the... Read more
Seals refrigerator door to prevent air leaks and maintain temperature. Replace if torn, warped, or letting warm air in. Confirm fit with model number.
The rubber seal/gasket was torn on our KitchenAid refrigerator right side door. I purchased the replacement and followed the directions/recommendations of how to prepare the new gasket for installation. When it's removed from the shipping box, it does have wrinkles and preparing it is a must. I set it out on our tile floor and then used a heat gun (low setting) to warm it up and massage it. It took me about 15 minutes, stopping and restarting as I let the rubber come back to it's desired shape.... Read more
Freezer freezing up or fridge running warm? This thermistor monitors temperature to control defrost cycles. DIY repair takes 1-2 hours with basic tools.
Toughest part of this repair is figuring out how to get things apart. Amana doesn't provide you a repair manual showing how to disengage the various plastic covers. Initially disassembled the bottom freezer compartment so I could get to the evaporator coils; they were completely frozen in block of ice, restricting air flow to the fridge above. Obviously, the auto defrost cycle had not been running, or was short-cycling. Manually defrosted. Found this link for running diagnostic tests on the... Read more
Clear plastic lid that covers the pantry drawer in your refrigerator. Replace if cracked, split, or broken. Snaps into place over hinge pins in minutes.
This part is 28-3/16 inches in length. If your original part was 30-1/2 inches in length you will need to order W10827015.
I researched the correct part I needed and ordered it. The part arrived in only 2 days. Installation was easy and the refrigerator is like new again. Read more
Loud noise or freezer warming up? This evaporator fan blade circulates cold air over coils. Simple DIY fix—most repairs done in under an hour.
The fridge is 20+ years old in a home we recently moved into. It sounded like a motor getting stuck on something or grinding weird... was hoping it wasn't something more serious. Found this site, clicked 'noisy' and got the replacement evaporator fan motor blade as well as the motor evaporator. Turned out I didn't really need to replace the fan blade, but since I had it and ours was old, figured I might as well put in the new parts. Followed the videos here, which were really helpful. The... Read more
Gallon-size door bin for refrigerator door storage. Replaces cracked, broken, or missing bins. Holds milk jugs, bottles, and large containers.
I looked up the parts online at AppliancePros.com! To my surprise, the detailed drawings showed that I could replace the center rail (about $13) instead of the entire lower shelf (about $100)! I also ordered a replacement shelf bin that had broken. I looked at other sites for the parts, but they were cheapest here. I ordered the parts LATE Wednesday and they were at my door Friday afternoon! Super fast! The order was accurate, packed well so it arrived damage free, Read more
Compressor won't start or kicks on and off? This run capacitor powers the compressor motor. A 15-minute DIY repair that restores cooling cycles.
Replaced relay and capacitor attached to compressor Read more
Seals your refrigerator's right-hand door to prevent air leaks and maintain temperature. Replace if torn, cracked, or not sealing properly. Confirm fit.
I searched online for replacement parts and Appliance Parts Pros had the part in stock. Before I ordered the part, I watched the video to see if I could handle the repair. I ordered the part and soaked the gaskets with warm water in the tub. The old gaskets had a much simpler setup, so no cutting was involved. I simply pulled the old gasket out of the track without issues, and installed the new one with finger pressure. Per the video, I took both doors off. However, due to the design, I could... Read more
Seals the freezer door to prevent cold air loss and frost buildup. Replace if torn, cracked, or no longer sealing properly. Verify fit by your model number.
We first emptied out the freezer to another freezer, turned off the refrigerator, and let it defrost. We ordered a freezer door gasket from Appliance Parts and it arrived within a few days. We watched the video on how to replace it, followed the directions, and the gasket was successfully replaced. However, while the freezer was off, I cleaned the inside. Unfortunately, we turned it on before it completely dried and the water in the tracks caused the drawers to stick. Now we have turned... Read more
Refrigerator making clicking or knocking noises? A faulty damper control causes noise and uneven cooling. Easy DIY repair—remove cover, swap unit in minutes.
Replaced the damper control. It took only 10-15 minutes. Since replacement, the clicking noise has stopped. Very happy with the result. However, want to share that there was probably nothing wrong with the original damper other than the original faulty design. The flap opens and closes and believe the clicking noise was the result of plastic against plastic. Noticed the new damper control is exactly the same as the original except that one of the flap sides now has a thick piece of rubbery... Read more
This hook supports and secures the rear of refrigerator shelves to the back wall of the compartment. Located on the refrigerator's back wall, replace it when shelves sag, won't stay level, or fall out of position.
First, I watched your VERY HELPFUL videos showing exactly how to remove and assemble the parts. I removed the salvageable parts from the old shelf frame and reassembled it. Read more
Supports the refrigerator door hinge for smooth opening and closing. Replace this pivot block if it's cracked, worn down, or broken to restore proper alignment.
We turned off the circuit breaker. We then removed the light cover and then the control panel. We disconnected the Keyboard, Utah, plugged in the new one and turned the breaker on to see if everything worked. We realized that we did not need a new jazz board so that is being returned. The old Keyboard was removed, the new one attached and all the parts were put back. The frig works fine now at the recommended settings of zero and 38F. Read more
By continuing to use our site, you agree to our Terms of Usage and Privacy Policy. You can learn more about how we use cookies by reviewing our Privacy Policy.
We use cookies to optimize website functionality, analyze the performance, and provide personalized experience to you. Use the controls below to manage your privacy preferences.
Cross-Site Advertising
When enabled, we may use cookies and similar technologies to deliver personalized advertisements based on your browsing activity across different websites. Opting out will disable third-party advertising cookies on this site.
Analytics Sharing
When enabled, we may share anonymized browsing and usage data with third-party analytics providers to help us understand how visitors use our site. Opting out will prevent this data from being shared with third parties.