Thermador Trim

Control panel trim for 36-inch electric ranges. Replaces damaged, cracked, or discolored trim pieces around the range control panel interface.

Replace your range hood's filter trim if the original is cracked, broken, or missing. This trim piece secures and frames the grease filter assembly.

This is a structural frame component used in a range hood ventilation system. It provides support and alignment for the hood assembly, helping to secure panels and ensure proper fit. Replace this frame if it is bent, cracked, or corroded, which can cause loose panels or rattling during operation.

This front freezer door trim restores the finished edge and appearance of a 36-inch freezer door. It replaces a scratched, dented or discolored trim to help the door look factory-fresh. What it does:

• Provides the finished front trim piece that attaches to the freezer door for a clean exterior appearance
• Replaces damaged, cracked or discolored trim that can make the door look worn
• Helps keep the door edge sealed and aligned by restoring the original trim fit
• Matches the original white finish for a consistent appliance look

• High-level replacement: remove door panel or existing trim fasteners to swap in the new trim; follow your model's service manual
• Retain and reuse any clips or screws only if they are undamaged and listed for reuse in the OEM guide
• Disconnect power or follow manufacturer safety guidance if removal requires handling electrical components

This island trim front assembly replaces the front-facing trim on a 36-inch island hood or downdraft to restore appearance and proper airflow coverage. It provides a finished look and aligns with the hood's ventilation opening. What it does:

• Replaces damaged, dented or scratched front trim to restore a clean, finished appearance
• Covers the front edge of the island hood/downdraft and helps direct airflow into the vent
• Helps re-secure adjacent trim and grille components that rely on the front piece for fit
• Reduces visual gaps or rattling caused by a loose or bent front trim

• One island trim front assembly (36 in.)

• Designed to mount using the hood's existing fasteners and attachment points; confirm orientation before tightening
• Handle with care to avoid scratching the finished surface during installation
• Disconnect power to the appliance if any adjacent panels or internal components must be removed