Wall Oven Panel Parts

Replaced bottom panel Read more

Ordered parts ( very easy) and replaced old ones . Pop out, pop in. Simple but it made my stove and oven new again. Read more

An aluminum drip pan was placed into the bottom of the oven thinking that it would make for easier clean up......Don't Do It! It melted to the bottom floor of the oven and could not be removed. It was infused with the coating on the floor pan, thus making it permanently damaged. After a quick search of the internet, a replacement part was found at AppliancePartsPros.com They had the part I needed at a very good price. It only took me about 5 minutes to change out the old part with the new one... Read more

I did research on my own prior to ordering. I looked at other sites, but was impressed with the online chatting-this was very helpful! I ordered three items and had difficulty with one rack. I called customer service and received a new rack the next day. This was meaningful to me because we were heading back home in a few days. The rep was very understanding to my situation and helpful. Read more

I first DISCONNECTED POWER FROM THE RANGE using the breaker. I then pulled the range out from the wall to give myself plenty of working room. I lifted the range top up as when you clean under the burners. I then moved the ends of the bottom of the slide rods that lock the range top open back where they came loose from the top of the range. This allows you to fold it higher and have complete access to the top of the range. I then took out all the Phillips head screws that hold down the sheet... Read more

The problem is a finicky ignition system, Direct Spark Ignition. Apparently Whirlpool redesigned the igniter/burner assembly slightly to make it more reliable. The repair is very easy. Turn off power, but you don't need to turn off gas. Remove oven bottom and flame spreader, then remove burner/igniter assembly, one screw at front, one at back. Lift out burner assembly carefully to avoid stretching wire. Pull electric connector from pin on burner/igniter assembly. Vacuum to clean oven. ... Read more

I ordered the new oven bottom from Appliance Parts Pros and within three days I had a brand new oven bottom. Took the old one out, the new one fit superbly. The next time I will definitely put foil or an oven liner on the bottom rack to catch the drips from the pies as the Aqua-lift cleaning system on the Whirlpool oven did not do the job. Read more

I replaced the Oven Igniter. After ensuring that it was the igniter, by turning on the stove and taking out the oven bottom. Watch if it turns red. If not, then either the wiring is faulty, or the igniter went bad. The bulb was due to a loose and broken light bulb, can't use any normal bulb, these ones are specially made to withstand the heat. And the oven bottom was warped due repeatedly heating up and cooling down over the years. It took a fair bit of time to get the new one in, since it was... Read more

4 screws, unsnaps from bottom. Read more

I ordered a new one from AppliancePartsPros.com. Read more