White Westinghouse Washer Dryer Combo Parts

Replaced drain hose and clamp. Read more

• Marks left on clothes

Recommendations have fun and a bucket to prevent losing parts. First watch the videos, practice disassemble and reassemble the dryer drum. Make certain you have a good screw driver and spatula from kitchen (could not find my putty knife). Secondly, clean and inspect everything, make sure the motor bearing and belt pulleys are in good condition with little or no play. Third after you have confidently disassembled, vacuum cleaned, inspected all the worn parts, grease the motor and pulley,... Read more

Simply open the top of the washer by inserting a putty knife (watch YouTube ) and then the front panel by removing two bottom philips head screws on the front. The whole front panel comes right off. Using pliers the spring clams holding each hose, they come off and each hose is replaced. The drain one was only leaking but since it has open I changed both and even the drive belt. Whole job less than 1 hour. BTW parts arrived next day! Read more

The agitator stopped functioning and there was a squeaking sound occurring in agitation mode. I found that if I cranked down on the agitator cap, screwing in as hard as I could, the agitator would work briefly, then the cap would loosen and agitator stop moving. I removed the agitator cap, along with which came the agitator stud cap and a rubber washer/seal which was jammed up into the underside of the cap. I lifted out the agitator from the drum and inspected it and the hub best I could.... Read more

I own several apartments with same washer/dryer combo. A couple months ago, one of my washers stopped agitating. I hired an Appliance Repair Company. They charged my $95 for agitator, $65 for hub and $120 for service call, plus tax for a total of $310. Oh, and it took them FOUR WEEKS to get the part in and fix my washer!. Something to do with "Frigidaire shipping issues". Last week I had another unit break with same problem. Ordered parts from AppliancePartsPros.com for $80, parts arrived... Read more

We had a power surge that tripped the washer breaker. It showed an E23 error code so I replaced the main control board (part number AP4362398.) All washer activity back to normal except it still wouldn't spin and still had E23 code. I removed the tub to pump hose (part number AP3837322) to find all sorts of goodies inside such as underwires from bras, a quarter, nickel, penny, and dime stacked perfectly on top of each other inside the filter, and tangled yarn from a rug. Ended up replacing the... Read more

The seal at the bottom of the tub had started to fail. On large loads water would leak so I ordered a new one rubber seal. Getting the trunnion off the transmission shaft was hard as it was calcified and corroded. I used a wire brush to get some of it off and then used a lot of WD-40. The bolt holding the trunnion plate on sheared off when I tried to remove it on one side and the other came out ok (the bolt hole through the trunnion is not threaded so it should slide out once the plate is off... Read more