Whirlpool Range Parts

In an attempt to clean the range from the grease-gunk build-up, I had to remove the burner heads. Unfortunately, the 2 most used burner heads had immovable screws that locked them into the orifices underneath. After numerous hours in attempts to salvage the old burner heads and orifices attempting to remove the immovable screws, I gave up. Checked Maytag's website for parts and found nothing. Turned to AppliancePartsPros.com and found the correct parts for reasonable price in a matter of... Read more

Replaced bulbs Read more

Ordered the knob and put it on ..works just fine Read more

I purchased the replacement element. The element was a direct replacement. The entire replacement took 20 minutes, 15 minutes of which was to clean the range before putting it back. Read more

Took down model# and tried to match on website. However there were 5 sub-models. Had to look very carefully at the pictures of the parts. Also, there were 3 different size caps on the range. Ordered one small, 2 medium, and one large. Arrived in 48 hours. Perfect match. Placed on burners. Repair complete. Read more

I ordered the knob and had it back and on my range before my pickles were ready to can. Loved the fantastic response time. Read more

Took apart the top of the stove and replaced ignitor Read more

I called a rpair service. The men came to the house, torn apart the stove top and advised Replacement of the wire harness. The trip charge of $100 would be deducted from a repair bill of $350, thus they needed an additional $150 for parts and $100 for labor after paying the trip charge. I bought the harness for $60, and the star bits I needed for my drill for $10. My son and I installed the new harness in about 30 minutes, which included a thorough cleanup, saving us $180. Read more

I ordered your collection of burner caps, which the store I bought the stove from could not locate, and it fit perfectly. Read more

Oven is a slide in. I pulled it out just a Few inches and removed 8 screws and Pulled the face down to expose the unit. The control unit had 4 screws and 4 Plugins. It only took me less than 10 Minutes to replace unit and slide back In place. Read more

Very easy, just push it on the spindle. Read more

What you will need: * replacement parts * small and regular Phillips screwdrivers * small wrench * soapy water in a spray bottle or leak detection spray Take apart the top of the stove control unit 1) turn off the gas to the stove, in my case I cannot get to the shutoff valve easily so I ended up turning off the electricity to the stove at the fuse box as that forces an emergency shutdown of the gas supply internally of the stove. 2) remove all 5 knobs, the grates at the top and open the oven... Read more

Replaced with a new handle Read more

Replaced open circuit thermistor at back of unit to restore power to stove. Replaced thermal fuse behind control panel due to high resistance in original one. Stove now operational. Read more