Whirlpool Refrigerator Drawer, Shelf, Pan

Ordered a front pan and it was so easy, snapped right on. Bin is fixed Read more

First, I watched your VERY HELPFUL videos showing exactly how to remove and assemble the parts. I removed the salvageable parts from the old shelf frame and reassembled it. Read more

So this is a poor design in the first case. Not having a center support in the back almost guarantees a failure there eventually. I kludged together a support in my original more than a year ago, but finally the part broke too bad to limp along with anymore. This is the part I needed. That being said, be very attentive about the fact that it's not the entire shelf assembly. There is a metal support across the front of the frame that is not included. The trim above the drawers, and the... Read more

I located the web site via the internet and contacted the 1-800 number. The service rep was incredibly helpful and personable. After providing her with the model number and parts needed,the process could not have been easier. My replacement parts arrived the next day a perfect match. I highly recommend using this service, first class all the way. Read more

They are easily replaced with no tools. Read more

Ordered replacement parts. Read more

Pulled out storage bin Removed side track rail covers Popped off gear from holding clip Installed drive shaft Installed rail cover and storage bin Only took about 15 minutes Read more

Yes exact fit Read more

It was a simple replace. Just had to pull out the broken bin and insert the new one. Read more

No instructions are included with either piece, which makes installation take more time and care. Tools needed: Small standard flat blade screwdriver, box knife or other knife with at least a 2" long blade, super glue. Remove the old main crisper frame: 1. Remove old main frame by lifting upward and outward. 2. Remove the center rail from the frame. May require bending of the main frame to remove it. 3. Remove the crisper front panel by unsnapping from frame. This is easily done by... Read more

Replaced the broken parts. The water leak was caused by the drain valve not directed into drain pan Read more

The manual had instructions for pulling things apart, the flaps over the drawer tops and the clear plastic inserts in the shelf. Flaps--Easiest to work with when the shelf is out and upside down. Slide flaps to the side a little to release the axle pin on the flaps from the receptacle hole on the shelf frame. Clear plastic plates are held in with a plastic pin on the side of the shelf frame. Carefully pull the side off the shelf there away from the pin slot until the insert pops out.... Read more

I installed the new guides on shelf number two, which then became our shelf number one and one went into the empty two place. All is well now. Read more

I took apart the old bucket with a screwdriver and put the new one with no problems. Read more

Ordered and installed new ones. Read more

Ordered and installed new ones. Read more