Whirlpool Washer Fuse Or Sensor

This door-mounted dispenser stores and releases detergent and rinse aid at the correct times during the cycle, helping restore consistent cleaning and drying results. Replace a worn or damaged unit to fix soap door and rinse aid issues.

• Holds detergent for the main wash and opens the cup during the programmed step
• Meters rinse aid into the final rinse to reduce spotting and improve drying
• Helps resolve symptoms like detergent left in the cup, soap door won't latch/open, leaking rinse aid, or poor cleaning performance
• Direct replacement for the original door dispenser assembly

• Disconnect power to the dishwasher before servicing
• Remove the inner door panel to access the dispenser; disconnect the wire harness
• Release the retaining tabs/screws, remove the old dispenser, and clean the sealing surface
• Seat the new dispenser flush, tighten mounting screws evenly, reconnect wiring, and run a test cycle to check for leaks and proper operation

This genuine replacement sensor monitors operating conditions in your appliance and restores accurate readings so controls can regulate cycles and performance. It's a direct-replacement sensing element used by the control system. What it does:

• Detects operating condition changes (temperature/level/position depending on application) so the control board can adjust cycles
• Helps eliminate cycle problems caused by faulty or intermittent sensor readings
• Commonly associated with symptoms like incorrect cycle behavior, error codes related to sensing, or inconsistent performance
• Works as the factory-designed sensing input for the appliance control system

• One sensor/sensing element as shown

• Disconnect power to the appliance before attempting service to avoid shock or injury
• Handle the sensor and connector carefully to avoid damage to terminals or wiring
• Reconnect wiring exactly as removed; ensure secure connector seating before testing