Whirlpool Washer Hose Or Tube

This replacement fill hose routes incoming water from the inlet valve to the washer tub so the machine fills properly. It restores proper water delivery and helps stop leaks caused by cracked or damaged hoses. What it does:

• Carries water from the inlet valve to the wash tub during fill cycles
• Prevents leaks and water loss when intact and securely clamped
• Can cause slow or no-fill symptoms if kinked, split, or detached
• Works with the washer's existing inlet valve and hose clamps

• One fill hose

• Turn off power and shut off the water supply before installing
• Inspect and reuse or replace hose clamps and any sealing gaskets as needed
• Route the hose without kinks and secure to the inlet valve/tub connections
• Check for leaks after restoring water and power

This replacement hose supplies water to your appliance to restore proper flow and prevent leaks. Use it when the original line is cracked, brittle, or leaking to re-establish a secure water connection. What it does:

• Carries water between appliance components to enable normal operation
• Replaces hoses that leak, are cracked, split, or collapsed
• Helps restore proper water fill and flow when low/no water is caused by a damaged hose
• Prevents water damage by providing a secure, intact water pathway

• One replacement hose

• Turn off water supply and unplug the appliance before starting any repair
• Inspect connection ends and replace or reuse clamps as needed for a secure fit
• Avoid sharp bends or kinks; route hose according to the appliance's original path

This drain hose carries wastewater away from the appliance so it can drain properly and avoid leaks or standing water. It restores proper water flow and helps prevent spills and floor damage when functioning. What it does:

• Routes wastewater from the appliance to the household drain or pump
• Enables normal drain cycles and prevents water from backing up
• Helps stop leaks and puddling caused by damaged or disconnected hoses
• Common symptom: visible leaks, poor or slow draining, or water on the floor

• One drain hose

• Disconnect power and turn off the water supply before beginning any repair
• Inspect hose ends and clamps; replace clamps if corroded or damaged
• Ensure hose is routed without kinks and secured to the drain or pump to prevent leaks
• Test the appliance through a full drain cycle after installation and check for leaks