White Outdoor Parts

Replace a cracked, broken, or missing discharge chute on your lawn mower. Mounts to the side or rear deck to expel grass clippings during cutting.

Wheel spacer for gas snowblowers. Installs between the wheel and axle to maintain proper spacing. Replace if cracked, worn, or missing from assembly.

Lower chute assembly for snowblowers. Directs snow discharge from the impeller. Replace if cracked, broken, or missing for proper snow routing.

Steering trigger handle for gas snowblowers. Mounts on handlebar to control steering mechanism. Replace if cracked, broken, or missing for proper control.

Throttle control knob for lawn mowers and tractors. Replaces cracked, broken, or missing knobs. Installs on the control panel for speed adjustment.

This trigger is a genuine MTD part that can be used as a replacement part for a snowblower operated by power steering. The trigger is located under the handlebars of a snowblower and functions as a crucial feature of the appliance's power steering capabilities. The trigger is connected to the tires through a network of cables through the engine, allowing effortless turning capabilities, even on tough, sharp turns. A trigger might have to be replaced if its material shows signs of deterioration, including bending, cracking, tearing, or melting. This deterioration can be attributed to general overuse or long-term exposure. If a trigger is subject to any of this kind of damage, it is best to replace it before using the snowblower, as the malfunctioning trigger might affect the power steering capabilities of the snowblower, creating an unsafe work environment and the possibility of permanent or unnecessarily extensive damage. Always wear gloves when handling, repairing, and operating outdoor equipment. This trigger is compatible with the brands MTD, Troy-Bilt, Yard Machines, and Cub Cadet.

Replaces cracked or missing grass deflector shield on walk-behind mowers. Mounts at discharge chute to control clippings and debris direction.

Spacer clip for self-propelled walk-behind mowers. Replace this securing clip if it's broken, missing, or no longer holding components properly in place.

Bumper cap for lawn tractors and riding mowers. Replaces cracked, broken, or missing bumper end caps. Installs on front or rear bumper assembly.

This curved polymer piece attaches to the bottom of the snow thrower housing to help guide snow flow and protect the auger housing from ground contact. Replace if you notice excessive scraping sounds, uneven snow discharge, or visible wear and cracking on the existing shoe.

Replacement chute flange keeper for snow throwers. Secures the discharge chute assembly to the housing. Replace if broken, cracked, or missing.

Replacement chute assembly for snowblowers. Directs expelled snow away from equipment. Replace if cracked, damaged, detached, or missing from unit.

Protective hub cap for walk-behind lawn mower wheels. Shields the wheel hub from dirt, debris, and moisture. Replace if cracked, broken, or missing.

Drive track wheel for snow blowers. Mounts on the axle to support and guide the track system. Replace if cracked, worn down, or causing track misalignment.