Need Help?
Call
Burner not heating or heating unevenly? This 6-inch surface element restores heat to your cooktop. Simple plug-in replacement takes 5 minutes.
Not really a repair, just needed to update some parts that were worn out. Drip pans were perfect and I am so glad to have found them on this location. Read more
Burner not heating evenly or has hot spots? This 6-inch surface element coil restores consistent heat for simmering and boiling. Simple plug-in fix.
Bought replacement burner receptacles. Cut off the old ones, used wire nuts to connect replacements. Read more
Color: black. It measures about 2 inches in diameter.
Ordered a knob and it fitted great!!! Read more
Pilot burner assembly for gas range surface burners. Provides continuous flame for ignition. Replace when pilot won't stay lit, flame is weak, or assembly is damaged.
Replaced pilot and thermocouple. ..pilot flame was weak ...wasn't heating thermocouple enough to power the valve Read more
Burner won't heat or heats unevenly? This 8-inch coil surface element restores reliable cooking power to your range. Simple plug-in installation.
It's one of the easiest jobs in the world. It take longer to unwrap the parts than to install them. Looks great...works great. Easy, Done. Read more
This terminal block provides an insulated, secure junction for incoming power or harness leads inside the appliance. Replacing a cracked, loose, or heat-damaged block restores a safe, reliable connection and helps prevent arcing or intermittent power.
I completely disassembled the entire unit sandblasted repainted with epoxy paint and reassembled. bought a few new parts and its like new again this unit is no longer available and its built into my boat. Read more
Burner won't spark or light? This range top burner igniter creates the spark to ignite gas burners. Easy 15-minute DIY fix for cracked igniters.
I found the model number on the stove and ordered a replacement. It arrived in two days. I replaced the old one and it works great. Read more
Replacement hinge for range oven doors. Sold individually; doors use two hinges. Replace if door won't stay closed, drops too fast, or is misaligned.
I had to take out the bottom drawer that holds pans. Disconnect the power and pull the oven out. Removed door, rear panel that held the screws for the side panel and lift up and out the side panel. After that it was straight forward as to replacing the hinge. Spent more time cleaning the florr where the oven was than installing the hinge. Read more
Replaces cracked, stained, or warped oven bottom panel in gas ranges. Covers burner assembly and provides smooth, cleanable floor surface. Easy install.
I ordered the new oven bottom from Appliance Parts Pros and within three days I had a brand new oven bottom. Took the old one out, the new one fit superbly. The next time I will definitely put foil or an oven liner on the bottom rack to catch the drips from the pies as the Aqua-lift cleaning system on the Whirlpool oven did not do the job. Read more
Replace a broken or fatigued oven door spring to restore proper counterbalance. Installs behind side panel. Ensures door closes firmly and seals correctly.
It was a simple fix. I removed the six screws holding the side panel on the range. Removed the broken parks of the spring. I use a screwdriver to help stretch the new spring into place. I then replaced the side panel and screwed it on. About ten minutes work. Read more
Auxiliary burner head for gas ranges and cooktops. Mounts over the orifice to distribute gas through precision ports. Replace if clogged or damaged.
Oven won't turn off or stays on low heat? This temperature-sensing thermostat regulates oven heat and prevents overheating. Moderate DIY repair.
I replaced the thermostat and its control switch as it was not able to turn off. Read more
Burner not heating or heating intermittently? This 8-inch surface element restores your cooktop. Easy DIY repair—just unplug the old, plug in the new.
The parts look great!!! Easy to put in....And parts came in 4 days..... Read more
Oven won't heat or overheats? This thermostat monitors temperature and controls heating elements. Moderate DIY repair requires back panel removal.
Removed back panel and top burner cover to replace thermostat Read more
This is a blower wheel used in the downdraft exhaust ventilation system of a range or cooktop. It mounts on the motor shaft and draws smoke, steam, and cooking odors down and out through the vent ductwork. Replace this part if the exhaust fan is noisy, vibrating excessively, or not moving air effectively despite the motor running.
I replaced the downdraft fan and fan motor of my 25 year old JennAire C301 cooktop. The issue was getting the fan/motor assembly out in such a tight place. I had to first remove the fan cover, cut the wires, then the assembly came out. Putting back wasn't as tough although getting the cover back on (over the motor) was a bit of a strain. Wired it back, turned it on, and was thrilled. Now I'll replace the knobs and burners and we're back in business. Read more
Washer won't start or spin? A broken lid switch actuator prevents the safety switch from engaging. This plastic striker restores proper operation in 5 minutes.
Replace the broken switch Read more
By continuing to use our site, you agree to our Terms of Usage and Privacy Policy. You can learn more about how we use cookies by reviewing our Privacy Policy.
We use cookies to optimize website functionality, analyze the performance, and provide personalized experience to you. Use the controls below to manage your privacy preferences.
Cross-Site Advertising
When enabled, we may use cookies and similar technologies to deliver personalized advertisements based on your browsing activity across different websites. Opting out will disable third-party advertising cookies on this site.
Analytics Sharing
When enabled, we may share anonymized browsing and usage data with third-party analytics providers to help us understand how visitors use our site. Opting out will prevent this data from being shared with third parties.