Range Trim

Replace cracked, broken, or missing oven door trim on your range. Covers the outer edge of the door for a clean finished look and protection from wear.

Trim kit frames your range oven door for a finished look. Replaces broken, cracked, or missing trim pieces damaged from regular use or heat exposure.

This decorative cap covers the end of the vent grille that allows hot air to escape from the oven door area. Located at the top front of the range door, replacement is needed when the cap is damaged, missing, or discolored from heat exposure.

Replaces cracked, broken, or missing trim on your range door. Restores a finished look, holds glass in place, and eliminates gaps around the door edge.

Black trim piece that installs at the bottom edge of your range oven door. Replace if cracked, rusted, broken, or missing to restore appearance.

 Color: Black

The Bottom Trim Channel is an OEM part for GE ranges and wall ovens. This trim piece attaches along the bottom front edge of the oven cavity, creating a seamless facade.

The bottom trim channel is responsible for covering any unsightly gaps and providing a sleek, finished look. It also acts as a protective barrier, shielding internal electronics and insulation from accidental impacts or liquid spills on the counter below.

Symptoms of a bad bottom trim channel include:

• Drooping, loose, or improperly fitted trim piece
• Exposed internal components behind missing or damaged trim
• Liquids or debris accumulating behind or beneath the channel

This OEM GE part is also compatible with Hotpoint, RCA, and some Kenmore models.

Black burner cap covers the sealed burner head on gas ranges. Replace if cracked, broken, or missing to restore proper flame distribution.

This fill kit supplies the water fill tube used to deliver water to the refrigerator ice maker so it can fill and produce ice reliably. It replaces a damaged or cracked fill tube to help restore proper ice production. What it does:

• Routes water from the household supply to the ice maker's fill cup
• Replaces cracked, split or frozen fill tubes that cause reduced or no ice production
• Helps stop leaks caused by a damaged fill tube
• Works with the ice maker's fill mechanism to restore normal fill cycles

• Shut off the refrigerator power and water supply before starting
• Inspect related water lines and connections; replace any damaged clamps or tubing
• Use basic hand tools; avoid overtightening fittings to prevent cracks

Replaces a cracked, broken, or missing vent door trim on your electric range. Restores the finished appearance around the vent opening. Black finish.

Trim cap for electric ranges. Covers and finishes control panel or body edges. Replace if cracked, broken, discolored, or missing for a complete look.

Trim panel for wall ovens and ranges. Covers gaps between stacked units or cabinet openings. Replace if cracked, broken, or missing during installation.

Black side frame trim for range oven doors. Replaces cracked, chipped, or warped door framing to restore proper fit and appearance. Easy installation.

Oven trim piece that frames the control panel or door edge. Replace if cracked, chipped, discolored, or missing to restore a finished appearance.

Decorative finishing panel that covers exposed edges on your range for a clean appearance. Replaces cracked, broken, or missing trim to restore look.

This trim is a decorative finish piece for select ranges and wall ovens. It covers gaps and raw edges for a clean look and helps keep adjacent panels properly seated when the original becomes cracked, bent, or missing.

• Provides a finished appearance by covering exposed edges or gaps
• Helps maintain alignment of nearby panels or glass
• Replace if cracked, warped, missing, or no longer seats securely
• Common symptoms include loose/rattling panels and exposed or sharp edges

• Disconnect power; for gas models, also shut off the gas supply
• Wear gloves—edges can be sharp
• Remove old trim and transfer/reuse original screws or clips
• Align the new trim and secure with existing fasteners; confirm proper fit before reassembly