Craftsman String Trimmer Parts

Starter rope won't retract after pulling? This recoil pulley and spring assembly fixes rope retraction issues on mowers and small engines. Direct fit.

Choke temperature control rod that regulates choke operation on walk-behind mowers. Replace if the metal rod is bent, broken, or disconnected from the choke.

Replace a worn drive sprocket if your chainsaw chain won't rotate or moves sluggishly. Simple installation in 15-20 minutes with basic tools.

Complete spark arrestor kit for line trimmer and blower mufflers. Replace worn, clogged, or damaged arrestor screens to prevent hot debris emission.

Replacement piston kit for gas trimmers, blowers, and handheld equipment engines. Includes piston and cylinder components. Needed when worn or damaged.

Idler pulley for walk-behind mowers. Maintains proper belt tension in the drive system. Replace if worn, cracked, or spinning roughly. Direct fit.

This replacement driver spring is a genuine OEM part for a string trimmer with a starter rope ignition. When an operator pulls the starter rope, the rope must recoil back into the starter assembly before it can be used again. This spring connects to a driver pulley in the starter assembly and maintains the right amount of tension needed to recoil the pulley. Over time, driver springs will begin to lose some of their tension. This is especially true if the operator is quite rough on their appliance. Pulling too hard on the starter rope can wear out the spring more quickly, making it less effective. Without a properly tensed driver spring, the starter rope will not recoil into the assembly. To change out the spring, use a nut driver to open the starter assembly and remove the pulley to get access to the old spring. Carefully remove it and install the new part. This replacement driver spring is a high-quality part designed to match the exact specifications for a Husqvarna or Jonsered appliance. This part is sourced from its original manufacturer and ships individually.

Rope won't recoil after pulling? This starter spring maintains pulley tension for automatic rope rewind. Standard DIY repair for most models.

Hard to start your leaf blower? A frayed or worn starter rope prevents pull-starting. This rope kit restores one-pull starting capability.

Keep your trimmer running clean with this air filter. Catches dirt and debris to protect the engine. Replace when clogged or damaged for optimal performance.

Vinyl rubber fuel line hose that connects the fuel tank to the carburetor. Replace if cracked, brittle, leaking, or damaged to restore proper fuel flow.

Replacement flex shaft for gas line trimmers. Connects the engine to the cutting head. Order a new shaft if yours is bent, cracked, or worn out.

Complete engine gasket kit for gas leaf blowers. Replace when engine runs rough, overheats, or loses power. Includes all essential gaskets. Verify fit.

Cylinder head for gas leaf blowers. Caps the cylinder block to seal the combustion chamber. Replace if cracked, warped, or damaged from overheating.