Crosley Fuse Or Sensor

This control thermostat regulates the dryer's operating temperature. It senses exhaust air heat and cycles the heater on and off to maintain consistent drying performance and help protect the appliance from overheating. What it does:

• Monitors exhaust temperature and controls the heating element to hold the selected heat level
• Helps prevent overheating by cycling heat off when the target temperature is reached
• Supports even drying and consistent cycle times
• Typical failure symptoms: no heat or not enough heat, long dry times, runs too hot, inconsistent temperatures

• 1 control thermostat

• Disconnect power before servicing; if gas, also shut off the gas supply
• Access location varies by model; typically mounted on the heater housing or exhaust duct
• Transfer wire leads one at a time to the new thermostat and secure with the original screws
• After reassembly, clean the lint path and ensure good airflow to prevent repeat failures

The Limiter is an OEM part for Frigidaire dryers. It protects the dryer from potential overheating. The limiter is designed to automatically cut power to the dryer's heating elements if temperatures become too high, preventing damage, fires, or other hazardous conditions.

Causes of a bad limiter can include general wear and tear over extended usage, exposure to excessive heat levels, or damage due to manual mishandling or accidental impact.

Symptoms of a bad limiter include:

• The dryer fails to turn off automatically at the end of cycles
• Clothes or interior drum become excessively hot
• Burning smells are detected from the dryer vent
• The dryer cuts out unexpectedly mid-cycle

This OEM Frigidaire part is also compatible with Electrolux, Gibson, Kelvinator and some Kenmore models.

A high limit thermostat that stops heat when a dryer's temperature gets too hot, helping protect the heating system and cabinet from overheating. It's a direct-replacement thermostat used in many gas and electric dryer heater assemblies. What it does:

• Opens the heating circuit if temperatures exceed safe limits to prevent overheating.
• Helps protect the heating element, housing, and internal components from heat damage.
• A failed thermostat can cause no heat or intermittent heating in the dryer.
• Works with the dryer's safety controls to maintain normal operating temperature.

• Disconnect power (and gas if applicable) before servicing; allow unit to cool completely.
• Located on or near the heater box or blower housing; follow your model's service manual for access.
• Replace with the exact part number to maintain original safety settings.

This 15 amp, 250 volt replacement fuse protects your appliance's electrical circuits by interrupting power when a fault or overload occurs. It restores safe operation once the underlying issue is fixed and the fuse is replaced. What it does:

• Acts as an overcurrent protection device for circuits rated up to 15 A and 250 V
• Prevents damage to wiring and components by opening the circuit during an overload or short
• Common symptom: appliance has no power or specific functions stop working after a sudden failure
• Replacing a blown fuse can resolve intermittent power loss or complete power failure tied to a single blown element

• Disconnect power to the appliance before inspecting or replacing the fuse
• Replace only with a fuse of the same amperage and voltage rating to maintain safety and proper protection
• Use insulated tools and avoid touching live terminals; internal access may require disassembly, follow OEM service instructions
• If fuses blow repeatedly, stop using the appliance.

This cycle thermostat regulates temperature during appliance heating cycles to help maintain safe, consistent operation and proper cycle performance. It replaces a worn or failed thermostat to restore correct temperature control. What it does:

• Senses and opens/closes at set temperatures to control heating during cycles
• Prevents continuous heating when the thermostat reaches its limit
• Can cause no-heat, overheating, or short cycling when faulty
• Works with the appliance's control system to maintain cycle timing and safety

• Disconnect power to the appliance before inspecting or replacing the thermostat
• Handle thermostat and terminals carefully; avoid bending sensing elements