Electrolux Wall Oven Parts

Found web site. Called the 800 number. Placed the order. 2 days later, they were at my door. Read more

Replace spark module. Read more

I diagnosed this problem via the web and the advice was spot on. The problem was a failure of the bottom door switch. I used a multimeter to verify that the switched never closed properly. It took me a minute to figure out how to remove the old switch (press a release tab under the switch while simultaneously rotating counter-clockwise). That was about the most difficult part of the repair. Read more

We took the old ones off and put the new ones on..it was easy to do ..I want to say that the girl (I think her name was Heidi) she was a big help ,she made sure that I had the right parts,I ask her to show me the picture to make sure that they look like the part ..She was a really big help. I did a survey when I ordered the parts to..Thank you for your help and the parts Anna P Read more

Remove front panel and replaced. Received parts fast. Read more

Conversion kit said put propane orifice .109 in to correct the problem but I had to use the .102 orifice. Read more

Turned off the power, removed the back cover and out with the old control parts, then installed the new parts Read more

Removed & replaced igniter switch assembly. The hardest part was figuring out how to remove the range top...look up a YouTube video with your manufacturer and model number to see how to do it. Read more

After turning off the gas and unplugging the electricity, I removed all the burners from the stove top using a 3/16" hex socket. Then used a 1/4" socket to removed two or three screws under each burner which hold the burner base to the bottom of the top panel. Then pulled all the knobs and removed the front panel which was held in by two Phillips screws accessible from underneath the panel. It helps to open the oven door to get at these screws. With the knob panel gone, I removed two screws... Read more

I went on your website found the parts needed to make the repairs. I watched the short video on installation. The parts arrived just a few days after I placed the order. I finished the repair in less than an hour and had to wait a few minutes to test the switch since the power was off and on due to a wind storm. Simple easy to do repair and I saved $90.00 on service fee for a tech to do the repair. Read more

Bought a new handle and installed it. Read more

We ordered a new ignitor and it came in two days just as promised. The only problem that we experienced was that the leads on the new ignitor were to short. We were able to find enough slack on the oven end to make it work. The oven is once again working great. The video was a little off on what need to be done to disconnect the ignitor. We actually had to flip the oven over to get to the bottom. We could not access the connector through the back. Read more

Found the parts I needed ordered them from your site Received them and installed in a few minuets and was done Read more

It is an easy job if you are good with screw driver and some general sense of things. Unplug the oven and than I opened the oven door and unscrewed two screws from bottom lift the glass door up and unscrewed the element coils total 4 screws there in total and pull the whole glass top out, removed the bracket from old glass top another 2 screws and 2 small brackets(snap on) from behind the glass top and put them on new one. slide the new glass top with back brackets into slot lift it up again to... Read more