Electrolux Washer Leg Or Foot

The Leveling Leg is an OEM part for Frigidaire washers. It is designed to provide stability and level the appliance properly on the floor during installation and operation.

Common causes for needing to replace the leveling leg include damage or wear over time, which can lead to unevenness and excessive vibration during wash cycles.

Symptoms that may indicate the need for a replacement leveling leg:

• Uneven or unstable washing machine
• Excessive shaking or vibration during spin cycles
• Difficulty in leveling the washer during installation

This OEM Frigidaire part is also compatible with Electrolux, Gibson, Kelvinator and some Kenmore models.

The Leveling Leg is an OEM part for Frigidaire dryers. It adjusts to stabilize the dryer on uneven floors during operation.

Subjected to vibrations, repeated adjustments expose leveling legs to wear over extended use. Causes of damage include common plastic stress fractures.

Causes of a problematic leveling leg can include:

• Loosened mounting allowing dryer movement
• Deformed, cracked or damaged plastic dampening
• Inability to adjust height or reliably stabilize weight

Symptoms include:

• Excessive shaking or noise related to an uneven base
• Difficulty configuring proper ventilation clearances
• Premature component fatigue accelerating repairs

This OEM Frigidaire part is also compatible with Electrolux, Gibson, Kelvinator and some Kenmore models.

This leveling leg threads into the base of your appliance to level and stabilize the cabinet. Replacing a worn or missing leg helps stop rocking, walking, and vibration, protecting the machine and floor for smoother, quieter operation. What it does:

• Provides adjustable height to level the appliance on uneven floors
• Stabilizes the cabinet to reduce vibration and noise
• Replaces a cracked/missing foot or leg with stripped threads
• Helps address rocking, walking, excessive vibration, rattling, or difficulty leveling

• 1 leveling leg

• Disconnect power; turn off water supply and move/tilt the appliance safely with a helper
• Thread the new leg by hand to avoid cross-threading
• Adjust all legs until the unit is level front-to-back and side-to-side
• If the leg uses a jam nut, tighten it to lock the setting; recheck level after initial use

This leveling foot assembly restores a stable, level base so your machine runs smoothly and stays in place. It replaces a worn or stripped foot with a new bolt, pad, and nut to secure the adjustment.

• Levels and supports the appliance by adjusting the foot height
• Helps reduce vibration, rocking, and walking during operation
• Replaces stripped, bent, or rusted foot bolts and worn or missing pads
• Holds the set height with the included nut to maintain alignment

• Disconnect power; for washers, turn off water supply before servicing
• Carefully tip and support the appliance to access the feet
• Thread the new foot into the base, seat the pad, and tighten the nut
• Level front-to-back and side-to-side; ensure all feet are firmly on the floor

The Leveling Leg is an OEM part for Frigidaire washing machines. These legs are designed to securely hold the washer in place while allowing adjustable height for proper leveling on uneven surfaces.

Causes of a bad leveling leg can include threads stripping or seizing due to regular height adjustments over time, as well as cracks or breaks from heavy loads or impacts.

Symptoms of a faulty leveling leg include:

• Excessive vibrating or horizontal movement of the washer during spin cycles
• Bowing or sagging of the washer cabinet
• Draining or filling issues due to improper drainage angle
• Premature component wear from long term poor leveling

This OEM Frigidaire part is also compatible with Electrolux, Gibson, Kelvinator and some Kenmore models.

Self leveling leg pad