Electrolux Washer Switch

The Water Level Pressure Switch is an OEM replacement part for Frigidaire washing machines. It senses the water level in the washer tub and signals to the control board when the tub is full. 

Symptoms of a faulty pressure switch include:

• The washer not filling or draining properly  
• No flow detection resulting in improperly filled or drained loads
• Unexpected or premature terminating of cycles
• Potential leaks from overfilling due to failed level sensing  

Causes can be normal wear over time exerting pressure on internal components, moisture exposure damaging electrical circuits, or impacts disrupting accurate pressure monitoring.

This OEM Frigidaire replacement part is also compatible with Electrolux, Gibson, Kelvinator, and Kenmore models. 

The Pressure Sensor Switch is an OEM part for Frigidaire washing machines. It is a component located near the pulsator that monitors water pressure within the washer tub during active cycles. The pressure sensor switch detects water pressure levels and transmits that input to the control board so it can regulate operation accordingly.

Causes for failure of the pressure sensor switch tend to be wear over time, accumulation of minerals/debris that impede functionality, or damage from unexpected water pressure rises. As a safety mechanism, this switch helps prevent overflow or other water-related issues by monitoring pressure inside the tub.

Symptoms of a bad pressure sensor switch include:

• Inability to advance to specific cycles like agitation or spin
• Error codes indicating pressure issues
• Cycles not completing properly or automatically stopping prematurely

This OEM Frigidaire part is also compatible with Electrolux, Gibson, Kelvinator and some Kenmore models.

This door switch senses whether the appliance door is closed and signals the controls to run only when it's safe. Replacing a worn or intermittent switch restores dependable starts and proper shutoff when the door opens. What it does:

• Detects door position and allows operation only when the door is fully closed
• Interrupts operation when the door opens for safety
• Common symptoms include: won't start, stops when the door is moved, or "door open" message/error
• Intermittent starts due to worn actuator or internal switch contacts

• 1 door switch

• Disconnect power before servicing
• Access the switch from the front or top panel; release mounting screws or tabs
• Move wires to the new switch one at a time to maintain correct positions, then secure the switch
• Test operation before reassembly

This water level pressure switch senses tub water level through an air hose and signals the control when to stop filling and allow spin. Replacing a failed switch restores proper fill levels and reliable cycle progression. What it does:

• Monitors water level via air pressure from the tub's air dome hose
• Signals the control to start/stop filling at the correct level
• Prevents overfilling and enables spin only when the tub is empty
• Common symptoms: overfills or underfills, won't fill, keeps filling, won't advance or won't spin

• Pressure switch

• Disconnect power and water supply before servicing
• Access the switch (typically under the top or rear panel) and release its mounting clip/screws
• Transfer wires one at a time; move the air hose to the new switch and ensure a tight, unobstructed connection
• Secure the switch and run a test fill/spin; inspect the air hose for kinks, cracks, or soap residue