Estate Insulation, Sound Dampening Parts

The Suspension Pad Kit is an OEM part for Whirlpool washers. It is a kit that includes 3 suspension pads designed to provide stability and reduce vibration during the washer's operation. These pads are designed to absorb shocks and prevent excessive movement.

You should replace the suspension pad kit if the pads become worn out or damaged. Causes of bad suspension pads can include regular wear and tear, overloading the washer, or continuous exposure to high levels of vibration and movement.

Symptoms of bad suspension pads include:

• Excessive shaking or vibrating during the wash or spin cycles
• Loud banging noises coming from the washer
• The washer moving or "walking" during operation
• Uneven or unbalanced loads despite proper loading

This OEM part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore models.

Size: 63-1/2 x 35-1/2 x 2-5/8 inch.

This insul-sound deadening pad reduces vibration and noise by dampening panels and components in laundry and kitchen appliances. It's a small adhesive-backed sound/isolation pad used where noise or rattles transfer through metal surfaces. What it does

• Dampens rattles and reduces structure-borne noise from panels, cabinets and housings.
• Helps isolate vibrating components from appliance chassis to lower perceived sound.
• Commonly applied behind control panels, cabinet walls or on motor mounts to cut vibration transmission.
• Useful when worn, detached or hardened factory pads allow increased noise.

• One insul-sound deadening pad

• Disconnect power before servicing an appliance to avoid shock or injury.
• Clean and dry mounting surface; press pad firmly to ensure adhesive contact.
• Replace only in the original location; do not cover vents or moving parts.
• If adhesive is weak, use OEM-approved adhesive; avoid solvents that may damage finishes.

This blower-housing pad is a replacement foam/rubber seal that cushions the blower assembly and helps maintain proper airflow and fit. It restores the original fit between the blower housing and cabinet to reduce vibration and air gaps. What it does:

• Cushions and supports the blower housing to reduce noise and vibration during operation
• Helps seal the blower housing to prevent air leaks that can reduce performance
• Maintains proper alignment and spacing of the blower assembly inside the cabinet
• Common symptom: excessive vibration, rattling, or airflow leakage near the blower area

• Designed for direct replacement; part number matches your unit before ordering
• Turn off power to the appliance at the breaker before beginning repair
• Handle foam/rubber parts gently to avoid tearing; ensure pad seats fully around the housing
• If other blower components are worn or damaged, inspect and replace as needed

This Block (mounting block) provides a stable anchor point used to secure components inside the appliance, helping keep parts aligned and reducing vibration for quieter operation. What it does:

• Secures or aligns adjacent components to maintain proper fit and function
• Helps reduce noise and vibration caused by loose or shifting parts
• Supports correct spacing to prevent rubbing or wear on moving parts
• Commonly replaced when the original is cracked, broken, or missing

• One mounting block

• Inspect surrounding mounts and fasteners; replace any damaged hardware
• Install with OEM-recommended fasteners and torque where specified
• Disconnect power (and water if applicable) before beginning any repair