Need Help?
Call or text
Plastic glide that attaches to the front of your range body to support the bottom storage drawer. Replace if cracked, broken, or missing for smooth operation.
Replaced guides Read more
Rear drawer glide for range storage drawers. Mounts to the back of the drawer to enable smooth sliding. Replace if broken, cracked, or missing.
First off, shipping was ridiculously fast. Ordered at 3:30pm EST, shipped same day, and arrived at my house by 10:30am the following day. This was with standard shipping. Granted, the package only was delivered from one state away, but WOW, was not expecting that. Replacement of the control board was much easier than I expected. I truly had it fixed in 15 minutes. The video was pretty much spot on. I user a single edged razor blade to carefully go around the edge of the overlay and remove it... Read more
Rear glide attaches to the back of your range storage drawer, allowing smooth sliding motion. Replace if broken, cracked, or missing to prevent drawer tilt.
The clips on the rear side of the drawer box were broken. Easy to locate the part on the website. Part in hand in two days and installed in about five minutes. Needed to remove the drawer and use a 1/4" driver, remove the broken slide and install the new one. Read more
Low-friction slide piece that supports moving components in your range or wall oven. Replace worn or cracked glides to restore smooth operation.
Low-friction glide that supports and guides range drawer movement. Replace if cracked, broken, or worn to restore smooth sliding without sticking or scraping.
Drawer slide glide for electric and gas ranges. Replace if cracked, broken, or worn to restore smooth, aligned drawer movement and eliminate sticking.
Replaces a worn, broken, or missing storage drawer glide for smooth sliding operation. Installs on the drawer track to restore proper alignment and movement.
I first needed to remove the panel that held the glide. I had to pull the stove out to access the back retaining screw (1/4 inch hex head). Then I had to remove the screw in the front of the stove. However, I used a square bit to remove the screw. I used a block of wood to tap the glide out of the sheet metal panel holding the glide. I used the block of wood to tap in the glide as well. I had to tap the glide into position so the glide and hole in the panel matched. Read more
Oven rack glide that allows smooth sliding of oven racks. Replace this guide if it's broken, cracked, or missing to restore proper rack operation.
Replacement drawer glide for electric and gas ranges. Guides storage drawer along its track for smooth opening and closing. Replaces cracked or worn glides.
Oven rack glide for electric ranges. Installs along the oven cavity wall to guide racks smoothly. Replace if worn, broken, or missing for proper support.
Rear slide guide for range oven racks. Mounts inside the oven cavity to support rack movement. Replace if cracked, broken, or causing racks to stick.
Replace your range's drawer guide if it's cracked, broken, or missing. This slide track ensures smooth operation of your warming or storage drawer.
Right-side slide track for wall oven racks. Mounts inside the oven cavity to guide and support oven racks. Replace when bent, damaged, or missing.
Oven rack slide track that guides oven racks in and out smoothly. Replace if your track is bent, broken, or damaged causing racks to stick or wobble.
Right inner drawer glide for range warming or storage drawers. Replaces cracked, broken, or worn glides causing drawer misalignment or difficulty sliding.
Usually ships within 4 - 14 days
Left drawer slide channel for electric ranges and ovens. Replaces cracked, bent, or broken guide rails that prevent smooth drawer operation.