Frigidaire Washer Parts

Washer overfilling or running without water? Your pressure switch likely failed. This switch monitors water levels to prevent overflow problems.

Cable tie secures wiring bundles and hoses inside your laundry center. Prevents loose routing, rubbing, and rattling noises. Replace if broken or missing.

Replace a cracked, broken, or worn washer door transition ring. This trim piece covers the gap where the door meets the cabinet for proper alignment.

This straight drum baffle creates tumbling action inside your dryer drum to lift and separate clothes for even drying. It extends from the drum wall to catch and lift garments as the drum rotates. Replace this baffle if clothes aren't drying evenly, take longer to dry, or if the original baffle is cracked or missing.

Replacement screw for securing panels, components, and assemblies in appliances. Needed when original screws are stripped, lost, or damaged during repair.

Molded balance ring that stabilizes the washer tub and reduces vibration during spin cycles. Replace if worn, cracked, or damaged to restore stability.

Secures the motor housing to its mounting bracket in washers and laundry centers. Replace if screw is missing, stripped, or damaged during service.

Replaces a cracked or broken splash tub cover assembly on your washer. Installs around the tub to protect internal components from water damage.

This dispenser valve assembly controls water flow to the fridge door dispenser for reliable dispensing and shutoff. It replaces a failed valve to restore proper water delivery and stop unwanted dripping or leaks. What it does

• Opens and closes the water passage when the dispenser actuator is pressed to deliver water to the glass.
• Seals the water line to prevent drips or continuous flow when the dispenser is idle.
• Helps stop intermittent dispensing or no-water issues caused by a faulty valve.
• Works with the door dispenser plumbing—electrical/connectors remain unchanged.

• Disconnect power and shut off the refrigerator water supply before starting.
• Remove the refrigerator door panel or access cover per your model's service instructions to reach the valve.
• Verify electrical connector seating and water line fittings are secure; replace any damaged tubing or seals.
• Test for leaks and proper dispensing after restoring power and water.

Secures hoses to fittings, preventing leaks in water and drain lines. Replace when connections loosen or leaks appear. Verify fit with your model number.

Power cord for washer installations. Replace if your original cord is damaged, frayed, missing, or shows exposed wiring for safe appliance operation.

Secures washer tub and suspension during transport or moving. Replace missing or lost shipping bolts to prevent vibration damage during relocation.

This replacement screw fastens panels, brackets, and internal components so assemblies stay aligned and tight during operation. With an 8-18 thread and 0.711-inch length, it matches the original hardware for a precise, reliable hold.

• Secures panels, brackets, and internal components to the cabinet/frame
• Replaces missing, stripped, or corroded screws
• Helps reduce vibration, rattling, and gaps from loose hardware
• Restores proper alignment after service or transport

• Disconnect power and shut off water/gas before servicing.
• Support panels/components while removing and installing the screw.
• Start threads by hand to avoid cross-threading; tighten snugly—do not overtighten.

This is the top work surface panel that covers the upper portion of the dryer cabinet. It provides structural support and a finished exterior surface while protecting internal components from dust and debris. Replace this panel if it is dented, cracked, rusted, or if the finish is damaged.

Secures water or drain hoses to fittings, preventing leaks and loose connections. Replace when hoses slip or drip to restore a tight seal.

Replacement #8 x 0.500 inch screw for securing panels, trim, and brackets in appliances. Needed when original fasteners are stripped, lost, or missing.