Gaggenau Dishwasher Parts

Hearing a metal on metal noise and not actually circulate water cancelling cycle worked fine After some web research, I concluded it was highly likely to be the circulation pump, so I watched the video on AppliancePartPros.com and realized it was a lengthy repair (a lot of steps) but not technically difficult. I simply played and paused the video at each step and duplicated the steps. The biggest things to take note of: 1) take good pictures of the wiring to use when you re-connect. 2) Wear... Read more

Ordered stainless door, stainless handle, power and control buttons, black toe panel, and black side strips. Read more

Replaced dispenser. It was hard to snap into place. You don't need to order separate gasket it comes with it. Read more

Used vids on youtube for steps on how to disassemble and install the pump; search "Bosch dishwasher circulation pump replacement". Also on AppliancePartsPro forums, a poster put up the Bosch "Dishwasher Service Training Manual" in .pdf. Search "Bosch dishwasher low pressure" on the forum. It's one of the post with the longest thread. Six pointers. 1. In another forum post, the poster noted that some hoses were brittle with age - and cracked when reinstalling. I had same issue (my washer is... Read more

The wash arms and filters were plugged with calcium and no longer spraying. Needless to say this impacts cleaning. The replacement parts were top quality and fit perfect. This simple replacement of parts put new life in trusty Bosch. Read more

ORDERED TUBE AND CLAMPS Read more

After we saw that progressively our dishes were not getting clean we investigated the condition of the spray arms and this upper feed tube assembly. We found a huge crack on the side of this piece and new not enough water was getting to the arms. We also noticed a build up of soap and lime. So we ran a cycle of vinegar and sprayed the filters and arms with lime-off-sprayed them out with a air hose "completely". Many of the small pieces of lime will clog the holes in the spray arms. Attached the... Read more

Using instructions I obtained over the internet, I first removed the DW's bottom cover panels so I could look inside the DW (with a flashlight) while it was running. I had to put their dishwasher through several wash cycles before I could pinpoint the location of the leak. (The water appeared to be coming from above on the left side of the DW, near the top, rear of the DW's blue "Pressure Chamber." Thinking that the problem likely lay in either a malfunctioning Pressure Chamber or in a... Read more

Removed old rollers and axels and installed new ones. Used needle nosed pliers to remove old axles and rollers and put new ones on by hand, just snapped them onto the rack frame and pushed new wheels onto the new axles. Discovered that the end caps of the metal guide that the rollers move in just rotate out on a hinge principle in order to remove the rack in order to put the new rollers on. Read more

Replaced the defective float switch. Read more

Took door off, saw that dispenser linkage was ok, I could open and close by hand, so figured the wax motor or the wiring to it were most likely the problem. I took off the wax motor ( actuator) and ran 120 volts to it via jumper wires, and it did not move at all, so figured good chance that was the problem. Found part # on your site, received new one quickly from you, put it in and works great. Thanks. Read more

Our Bosch suddenly quit washing the dishes properly after 15 years of faithful service. I observed that there was no pressure coming from the sprayers, and determined it to be the circulating pump. I could reach into the pump from inside the dishwasher and could feel that something was loose in there - the impeller moved when pumping, but I could stop it with my finger. When I took the pump out and disassembled it, the impeller was in two pieces (the front and back pieces that are supposed... Read more

Ordered a replacement control panel and installed it according to the AppliancePartsPros.com YouTube video. Read more

Ordered the parts and had a local appliance store do the work, complete Job for $ Read more

• overflowing
• Will not fill with water

The indications made me think the dishwasher was not shooting water. I checked the water valve with a voltmeter and it was getting power to open. I disconnected the line to make sure the water line was not plugged. Then I bypassed the door switch and ran the dishwasher with the door open and did not see the water filling which pointed to the inlet valve. I ordered the valve which came quickly. Replaced the valve and now the dishes are clean! Read more