General Electric Cooktop Cable Or Retainer

Retainer wire secures internal cooktop components. Replaces worn, broken, or missing wire that no longer holds parts in proper position.

Conduit wire assembly protects electrical wiring in your cooktop. Replace if the conduit is cracked, damaged, or missing to restore proper wire protection.

This strain relief secures the appliance power cord where it enters the cabinet, preventing pull, chafing, and wire stress for safer, more reliable power connections. It's a simple, low-cost part that helps protect wiring from damage. What it does:

• Clamps and holds the power cord to reduce strain on internal wiring and terminal connections
• Helps prevent cord pull-out, fraying, and exposed conductors that can cause intermittent power or arcing
• Keeps the cord routed and positioned to reduce vibration wear over time
• Commonly replaced when cords are loose, damaged at the entry point, or when the clamp is broken

• One strain relief clamp

• Disconnect power at the breaker or unplug the appliance before starting any work
• Remove the access panel or back panel as needed to reach the cord entry; keep fasteners for reassembly
• Position the cord, seat the strain relief in the cabinet opening, and secure per original mounting (screws or snap-fit depending on model)
• After installation, restore power and verify steady operation; stop and recheck if you see sparking, burning smell, or intermittent power

Strain relief cable retainer for ranges. Secures and protects electrical wiring at connection points. Replace if cracked, broken, or missing.

This small replacement clip secures cabinet insulation in place to help maintain proper thermal performance and reduce vibration. A simple, original-equipment style retainer for restoring insulation fit and keeping internal components covered. What it does:

• Holds appliance insulation against the cabinet or inner panels
• Helps prevent insulation from sagging, shifting, or falling into vents or components
• Can reduce noise caused by loose insulation and help maintain temperature control
• Commonly needed when clips are broken, corroded, or missing

• One insulation retainer clip

• Disconnect power (and water if applicable) before accessing internal panels
• Remove access panels or liners to reach the insulation area; retain fasteners
• Push or snap the retainer into the designated hole/slot; some models may require light prying or a screwdriver for removal
• Wear gloves and eye protection to avoid cuts from sharp sheet metal and insulation fibers