General Electric Cooktop Control Board

Replacement touch control board for cooktops. Installs under the cooktop surface. Needed when the existing board is damaged, unresponsive, or malfunctioning.

Distributes power to control and heating circuits. Replace when board is damaged, failed, or non-responsive. Installs at bottom of cooktop unit.

Secondary relay board that switches power to cooktop burners and heating elements. Replace if cracked, damaged, or causing intermittent control issues.

Control board that mounts to the main control assembly. Replace when board is burned, damaged, or relays have failed to restore proper operation.

Gas burners won't light? This ignition generator board sends spark signals to igniters for reliable burner lighting. Intermediate difficulty repair.

Range display lights flickering or completely dark? This LED power supply module converts voltage to power your control panel lighting. Moderate DIY repair.

Logic display circuit board for cooktops. Controls touchpad interface and display functions. Replace if display is blank, unresponsive, or damaged.

Power control board for your cooktop. Regulates electrical functions and burner operation. Replace if the original board is damaged, corroded, or faulty.

This filter board is the electronic control board that monitors and communicates your refrigerator's filter status and related dispenser signals, restoring proper filter detection and indicator operation. What it does

• Monitors filter presence and communicates filter status to the display or dispenser
• Sends/receives signals that enable filter-related indicator lights and alerts
• Helps restore dispenser/filter indicator functionality when the original board fails
• Common symptom: filter status light stays on or does not change after replacing the filter
• Common symptom: dispenser or filter indicator behaves intermittently or not at all

• Disconnect power to the appliance before starting service to avoid shock
• Handle the board by the edges and avoid touching contacts; protect against static discharge
• Access typically requires removing the dispenser/display or control housing—retain screws and mounting hardware

This right-side generator board is the replacement control board that completes the unit's ignition/control circuit, restoring proper operation and reliable starts. Use it to replace a damaged or non-responsive right-side generator board. What it does:

• Routes ignition/control signals to the right-side components and helps enable proper spark or control functions
• Common symptom: no ignition or intermittent starting on the right side
• Common symptom: erratic or no response from the affected side's controls
• Helps restore normal operation when the original board is cracked, burnt, or electrically damaged

• Disconnect power (and gas, if applicable) before starting any repair
• Handle the board by the edges and avoid static discharge; use ESD precautions if available
• Inspect connectors and wiring for heat or corrosion; replace damaged wiring or connectors

Touch control circuit board for 30-inch cooktops. Replace this electronic control panel if buttons are unresponsive, cracked, or display is damaged.

Generator control board for cooktop center module. Replaces cracked, damaged, or malfunctioning circuit board. Mounts inside cooktop control assembly.

Touch control board mounts behind the touchpad interface on electric cooktops. Replace if controls are unresponsive, locked, or buttons fail to register.

Left-side generator module circuit board for cooktop ignition control. Replaces damaged, non-functioning, or corroded modules. Installs on left burner.