General Electric Cooktop Support Parts

This is an orifice carrier assembly used to convert a range from natural gas to liquid propane (LP) operation. It includes the properly sized orifices needed to regulate LP gas flow to the burners. This kit is needed when installing a natural gas range in a location that uses propane, or if burner flames are too high or too low after a gas type change.

Maintop support plate mounts beneath your cooktop burner assembly. Replace if the original is cracked, warped, or corroded to restore stability.

Burner hanger bracket for cooktops and ranges. Secures burner assembly to cooktop surface. Replace if bracket is bent, broken, or missing.

Mounting plate that secures and supports the wiring harness in your cooktop. Replace if cracked, broken, or missing to properly secure electrical connections.

Secures and positions your cooktop burner assembly for proper alignment and stability. Replace this bracket if yours is bent, worn, or broken.

Left hand side

This bracket element support holds and stabilizes the oven's bake/heat element so it stays properly positioned for reliable heating and safe operation. Durable replacement for a sagging or loose element mounting point. What it does:

• Secures the oven heating element to prevent sagging or contact with the oven cavity
• Helps maintain consistent element placement for even heating
• Reduces stress on the element that can cause buzzing, arcing, or premature failure
• Restores proper element alignment after impact or wear

• One bracket element support

• Disconnect power to the appliance before inspecting or replacing the part
• Handle the heating element and mounting area carefully—sharp edges may be present
• Follow the appliance service manual for step-by-step removal and reassembly