General Electric Dishwasher Dispenser Parts

Dishwasher service dome coarse filter traps food debris during wash cycles. Replace if leaking, cracked, or worn to prevent water leaks. Verify fit by model.

This pump housing channels washer drain water from the tub to the drain pump and helps seal the pump assembly to prevent leaks. Replacing a cracked or worn housing restores proper drainage and helps stop leaks under the washer. What it does

• Directs wastewater from the tub into the drain pump so the machine can pump out water
• Seals the pump to the washer tub to help prevent leaks at the base
• Can cause poor draining or standing water when cracked or damaged
• A damaged housing may produce unusual pump noises or visible leakage

• 1 pump housing

• Disconnect power and shut off water before starting any repair
• Drain remaining water from the washer and remove the access panels as required
• Installation typically requires removing the drain pump/motor and transferring seals or gaskets
• Inspect clamps and hoses for wear and replace if needed; test for leaks after reassembly

Replacement upper cap for dishwasher dispenser tower assembly. Restores finished appearance when original cap is cracked, broken, or missing.

Protective cover for dishwasher power board. Shields electrical components from debris and accidental contact. Replace if cracked, broken, or missing.

Plug button cap for dishwasher control panel. Replaces worn, cracked, or missing button covers. Restores clean appearance to front controls.

Replacement junction box cover for your dishwasher. Secures and protects electrical connections. Order a new cover if yours is cracked or missing.

Replace your dishwasher's door latch cover insert if cracked, broken, or missing. This plastic cover installs over the latch mechanism for a finished look.

Model selector plug assembly for dishwashers. Installs on the control panel to cover and protect selector switch openings. Replace if cracked or missing.

Model selector plug cap for dishwashers. Installs on the control panel to cover the model selection switch. Replace if cracked, broken, or missing.