General Electric Range Bumper, Bushing, Grommet Parts

This rubber bumper cushions and protects appliance components from impact, vibration and rubbing, helping reduce noise and wear. It restores proper spacing where a worn or missing pad lets parts contact or vibrate. What it does:

• Acts as a soft stop to prevent panels, doors or components from striking each other
• Dampens vibration and reduces rattling or buzzing during operation
• Keeps moving parts aligned by maintaining proper clearance
• Helps prevent cosmetic damage from rubbing or repeated contact

• Locate the damaged or missing bumper and remove any debris before installing
• Press or seat the bumper into the mating hole or surface until fully engaged
• Use common hand tools if needed; avoid sharp tools that can tear the bumper
• Disconnect power or follow appliance-specific safety steps before working near electrical components

This wire bushing protects appliance wiring where wires pass through metal or plastic panels, helping prevent chafing and shorts. It restores a safe insulating barrier to wiring harnesses and terminals. What it does:

• Cushions and isolates wires where they pass through openings to prevent abrasion and wire damage
• Helps stop rubbing that can wear insulation and cause arcing or shorts
• Reduces risk of intermittent power, blown fuses, or burning smells from damaged wiring
• Restores proper routing and strain relief for affected harnesses

• Remove power to the appliance before accessing wiring; disconnect power at the breaker or unplug.
• Inspect surrounding wire insulation and harness for damage; replace any wires that show charring or exposed conductors.
• Push the bushing into the opening until seated, then route the wire through the bushing to ensure a snug fit.

This standoff is a small mounting support used to secure internal panels or circuit boards and keep wiring clear of metal surfaces, helping prevent contact and vibration-related issues during operation. What it does:

• Provides a stable anchor point to mount control boards, panels, or wiring assemblies
• Keeps wires and components spaced away from chassis to reduce shorting risk
• Reduces vibration and rattling by holding parts firmly in place
• Helps maintain correct alignment of serviceable assemblies for reliable operation

• Disconnect power to the appliance before servicing to avoid shock or damage
• Use appropriate fastener (screw or clip) as originally installed; do not overtighten plastic standoffs
• Handle nearby circuit boards and wiring gently; avoid bending traces or connectors

Spacer for electric ranges. Installs to maintain proper clearance between components. Replace if cracked, worn, or missing to restore correct spacing.

Replacement bumper for range maintop. Cushions and protects the cooktop surface. Replace if cracked, broken, worn, or missing to prevent damage.