General Electric Range Chassis Or Cabinet

Replace your gas range's damaged or worn oven top panel. This structural cover installs over the oven cavity, restoring your range's appearance.

Replacement back panel for your range oven. Installs behind the oven cavity to enclose the unit. Needed when the original is cracked, damaged, or missing.

Replaces the bottom panel inside your electric range oven cavity. Order a new bottom when the original is cracked, rusted, warped, or damaged.

Replaces the worn, cracked, or dented top surface panel on your electric range. Restores a clean cooking area and improves overall appearance.

This bottom panel replaces the damaged lower oven floor panel to restore proper support and heat protection for cookware and internal components. It helps stop rattling, sagging, and hot spots that can affect bake performance. What it does:

• Provides a stable, heat-resistant surface at the bottom of the oven cavity
• Protects underlying components from spills, drips and direct heat
• Prevents sagging or warped oven floor that can cause cookware instability
• Can reduce rattling or vibration caused by a loose or damaged panel

• Disconnect power to the range before beginning any work.
• Remove oven racks and allow the oven to cool completely.
• Handle edges carefully; use gloves to avoid cuts and protect the finish.
• Installation typically requires removing access screws and aligning the panel into the oven floor supports.

Side panel for range broil compartment. Replaces damaged, scratched, or discolored exterior panels. Restores structural integrity and appearance.

Replace your range's main bottom panel if the structural base is cracked, damaged, or missing. This panel supports the chassis and cabinet framework.

Main back panel for your range. Provides structural support and houses internal components. Replace if cracked, damaged, rusted, or warped from heat exposure.

Oven cavity wrapper assembly forms the outer shell around the cooking chamber. Replace if cracked, damaged, or rusted to restore structural integrity.

Replacement front frame for your range. This structural component forms the outer cabinet edge. Order a new frame if yours is damaged, cracked, or warped.

Interior oven body weld assembly for ranges. Structural frame that forms the oven cavity. Replace if cracked, rusted, warped, or damaged from wear.

Cooktop box assembly for electric ranges. Houses and supports the cooktop surface. Replace if cracked, damaged, warped, or showing structural wear.

Lower panel that supports the oven's gas burner area. Replace if cracked, warped, or corroded to restore structural integrity and proper burner alignment.

Retains insulation along the side panel of your range. Replace if the retainer is cracked, broken, or missing to properly secure insulation in place.

Back insulation retainer panel for ovens and ranges. Secures insulation to the rear cabinet. Replace if cracked, broken, or missing to restore proper fit.