General Electric Range Screws, Nuts, Washers

Genuine Ge part

Ge Rivet

By: Ge

Part Number: WB2X7496

$3.41

Compare At:: $6.68
You Save:: $3.27

Out Of Stock

Usually ships within 4 - 14 days

Add to Cart

Genuine Ge part

This flat washer is a simple replacement spacer used in appliance assemblies to maintain proper spacing and reduce friction between moving parts. It restores correct alignment and helps prevent noise and premature wear. What it does:

Provides a stable spacer between components to maintain correct clearance
Reduces friction and wear on shafts, bearings, or fasteners
Helps stop rubbing noises caused by misaligned parts
Restores original fit where a worn or missing washer causes play

What's included:

One flat washer as shown

Install notes:

Disconnect power and water supply before servicing appliances
Confirm orientation and placement against the original washer before removal
Use basic hand tools; replace any damaged fasteners or adjacent parts for best results

$8.58

Compare At:: $9.44
You Save:: $0.86

Out Of Stock

Usually ships within 4 - 14 days

Add to Cart

Genuine Ge part

Ge Screw

By: Ge

Part Number: WB4X366

$35.57

Compare At:: $38.62
You Save:: $3.05

Out Of Stock

Usually ships within 4 - 14 days

Add to Cart

Genuine Ge part

Ge Nut (Mounting), 1 Count

By: Ge

Part Number: WD1X1289

This is a replacement mounting nut that secures components to their mating studs or shafts, restoring proper fit and preventing looseness that can cause noise or misalignment. Use it to replace a worn, stripped, or missing nut. What it does:

Fastens parts to studs or shafts to keep assemblies secure and aligned.
Prevents wobbling, rattling, and reduced performance caused by a loose or missing nut.
Restores reliable mechanical connection after thread damage or corrosion.
Works where a standard hex-style fastening nut is required by the OEM design.

What's included:

One replacement mounting nut.

Install notes:

Disconnect power and unplug the appliance before beginning work.
Verify correct stud engagement and thread direction before tightening.
Use the proper-sized wrench and tighten to the manufacturer's recommended torque; avoid over-tightening to prevent thread damage.
If threads are damaged, replace the mating stud or use an approved repair kit—do not force a nut onto stripped threads.

$6.47