General Electric Range Trim

Decorative trim piece that covers the toe kick area at the base of your range. Replace if cracked, chipped, discolored, or missing for a complete look.

Replace your range's damaged or missing toe kick trim panel. This bottom trim piece covers the gap between your range and floor, providing a finished look.

This trim vent weld assembly secures and finishes the dryer vent opening for a clean, stable fit. It restores proper vent alignment and helps maintain airflow where the vent meets the appliance exterior. What it does:

• Provides the finished trim and welded mounting needed at the appliance vent opening
• Holds the vent in place to prevent gaps and reduce air leaks around the vent
• Helps restore proper vent alignment after damage or rusted trim
• Commonly replaced when the vent trim is bent, broken, or detached

• Install with appropriate hand tools; inspect surrounding sheetmetal for damage before fastening
• Use care to avoid sharp edges; wear gloves and eye protection during installation
• Confirm fit with the appliance model and part number before installation
• If venting issues persist after replacement, inspect vent ductwork for obstructions or damage

This toe kick top is the replacement cabinet trim that covers the gap at the base of the appliance to restore a finished look and protect underlying components from debris. It's a simple cosmetic and protective panel. What it does:

• Replaces a cracked, dented, or missing base trim to improve appearance
• Covers exposed fasteners and gaps at the appliance base
• Helps keep dust and debris out of the lower cabinet area
• Restores a secure mounting surface for the lower grille or kick plate

• One toe kick top panel

• Remove the lower grille or kick plate before installing; keep fasteners organized
• Align mounting tabs or screw holes and secure with the original hardware
• Wear gloves to avoid sharp edges and protect the finish during installation
• Replace damaged clips or screws before mounting the new panel

This access back panel covers the rear of the appliance to protect internal components and restore a finished appearance. It provides a secure mounting surface and keeps wiring and parts enclosed for safe operation. What it does:

• Covers and protects internal wiring, controls and components at the appliance rear
• Restores a finished exterior and helps prevent dust and debris entry
• Secures with factory mounting points to stop rattling or loose panels
• Replaces missing, bent, or corroded rear access panels that expose internal parts

• Disconnect power and pull the appliance away from the wall before installing.
• Use correct screws and hardware for secure mounting; verify alignment with factory holes.
• Handle edges carefully; wear gloves to avoid cuts.