General Electric Wall Oven Bracket & Flange

Right side mounting bracket for ranges and ovens. Secures the appliance body to the chassis. Replace if bent, cracked, or missing during installation.

This fan bracket is the mounting support that secures a range/vent/evaporator blower assembly so the fan stays aligned and operates quietly. It restores proper fan placement to reduce wobble and intermittent contact. What it does

• Holds the fan or blower motor assembly in the correct position to maintain stable rotation.
• Prevents the fan from rubbing or vibrating against the housing, which can cause noise.
• Helps restore airflow path when a damaged bracket allows the fan to shift.
• Addresses symptoms such as noisy or rubbing fan operation, intermittent fan contact, or reduced airflow due to misalignment.

• One fan bracket as shown.

• Disconnect power to the appliance before starting any work.
• Access typically requires removing panels or the blower housing—keep fasteners organized.
• Inspect surrounding mounting points and replace any damaged screws or clips for a secure fit.

A side pan reflector that directs heat inside the oven cavity and helps protect the oven interior. Replaces a damaged or worn reflector to help maintain even heating and reduce hot spots during cooking. What it does:

• Reflects and redirects oven heat for more consistent cooking and baking
• Shields the oven wall from grease, spills and direct heat exposure
• Helps reduce uneven browning or hot spots caused by a missing or warped reflector
• Visible damage, excessive soot or warping are common signs the reflector needs replacement

• One side pan reflector

• Allow the oven to cool and disconnect power before installing
• Remove any loose debris or grease from the mounting area before fitting the new reflector
• Confirm correct side/orientation and secure per the oven's hardware; use manufacturer instructions when available

This H.V. bracket secures specific high-voltage or control assemblies to the appliance chassis, keeping components stable and properly aligned so wiring and parts stay protected during normal operation. Durable stamped metal design for reliable support. What it does:

• Holds and positions high-voltage/control assemblies or related components to the appliance frame
• Stabilizes wiring and connectors to reduce strain and prevent intermittent electrical contact
• Helps maintain correct clearance and alignment for safe, consistent operation
• Can address symptoms like loose components, rattling near the control area, or intermittent electrical connections when the bracket is damaged or missing

• One H.V. bracket

• Turn off power to the appliance before attempting any service to avoid risk of shock
• Install in the original mounting location using the factory screws or hardware; do not force into place
• Inspect related wires, connectors, and fasteners while replacing the bracket and replace any damaged items