General Electric Wall Oven Screws, Nuts, Washers

I was getting really frustrated with our oven. It would preheat to the correct temperature, then slowly lose heat until it was down to about 200 degrees. So it took about two hours to heat a pizza! Finally decided to repair the oven myself, rather than pay $300.00 to have a repair person come out. Ordered the replacement igniter from AppliancePartsPros.com, and it arrived in two days. I followed the instructional video on the AppliancePartsPros.com website, and it was going well until I... Read more

It was very easy!. Just removed the screws off the trim plate and access was right there. The double oven was given to me but the handles were missing and the end caps so I just had to replace them. Read more

Move stove to unplug, remove rear center panel, indentify the two spade connectors that feed the heating element and remove (unplug) them. Remove two screws that hold the element to the inside rear wall of the stove and remove element. Install new element, plug in the previously removed spade connectors, re-install rear center panel, plug range (power) in, move stove back into place and enjoy. Read more

I took the cover off and the fan had separated from the bushing. Ordered a new fan and nut and it took all of 5 minutes to replace. Probably saved $159.99 service call repair and that is with a coupon. Any one can do this repair, just make sure the oven is cold as you will come in contact with metal parts. Read more

We replaced the broken door hinge. Read more

Great site to DIY! Purchased fresh produce drawer railing and parts. Fixed in under 10 minutes. Thanks so much! Read more

I positioned the element under the top of the stove and placed it back in there with the bracket and screw. Turned out perfectly. Read more

A new electrode and the great schismatics on your website. The only thing that took some time was removing the 2 screws in burner pan. Once removed it was very easy to fix. Read more

I did some research on my own and then spoke with the “Pros” at Appliance Parts Pros. Both confirmed the main board needed to be changed. The other less likely item was the oven sensor. I changed the sensor first as it was inexpensive. The error codes continued. Subsequently, I then changed the main board which was slightly difficult. When changing 2 screws hold the board in place on each front corner only. Also suggest you take a picture of wiring. I replaced wiring in place from old board to... Read more

Purchased new burner assemblies and burner grates from Appliance Parts Pros to replace old, worn out ones. This job was easy as all parts purchased were unpack and place. My range is about 15 years old but is in pristine condition so instead of replacing the range, I chose to replace dirty, worn parts. Read more

Went on line to the FAQ and ordered the 2 units suggested. The install was very easy and had the stove back online in 1/2 hour Read more

Replace screws Read more