General Electric Washer Bumper, Bushing, Grommet Parts

This double-style hinge bushing supports the washer lid hinge pin and provides a smooth bearing surface. Replacing a worn bushing restores quiet, even lid movement and helps keep the lid properly aligned over time.

• Supports and centers the lid at the hinge
• Provides a low-friction bearing surface for the hinge pin/rod
• Helps reduce squeaking, looseness, and metal-on-metal wear
• Can help resolve a wobbly, misaligned, or scraping lid

• Disconnect power before servicing; support the lid to prevent dropping
• Remove the hinge pin/rod or screws as your model requires to access the bushing
• Pry out the worn bushing and press the new bushing fully into the hinge opening
• Reassemble and check lid operation; consider replacing the opposite-side bushing if worn

This small bushing fits the washer's lid hinge to provide a smooth, stable pivot. Replacing a worn hinge bushing restores proper lid alignment and helps reduce squeaks, rubbing, or excessive play when opening and closing the lid. What it does:

• Acts as a low-friction sleeve between the hinge pin and bracket
• Supports smooth lid movement and helps maintain alignment
• Reduces metal-on-metal wear and hinge noise
• Symptoms of wear can include squeaking, binding, scraping, or a loose/wobbly lid

• 1 hinge bushing

• Disconnect power before servicing
• Support the lid to prevent it from dropping when the hinge is loosened
• Remove hinge hardware to access and swap the bushing; reassemble and check lid alignment
• Many models use a bushing on each hinge—inspect both sides and replace as needed

This panel locator secures and positions the control or trim panel so it stays aligned during normal use, preventing rattles and misalignment. It's a small replacement part that restores proper fit and finish to the panel assembly. What it does:

• Holds the control/trim panel in the correct position to prevent shifting or rattling
• Replaces a broken, cracked, or missing locator that causes an uneven or loose panel
• Helps maintain panel alignment for a clean appearance and proper function
• Used where a snap-in locator or mounting tab has worn or failed

• One panel locator as shown

• Basic hand tools may be required; remove power to the appliance before starting
• Inspect surrounding clips and mounting points; replace other damaged fasteners as needed
• Press or snap the locator into the panel slot until it seats securely; avoid excessive force