General Electric Washer Shaft Or Pin

Alignment pin keeps washer door hinge positioned so the door closes evenly. Replace if cracked, bent, or missing to restore proper door fit and seal.

Grounding stud for top-load washers. Connects electrical ground wire to washer frame. Replace if stripped, corroded, or missing for proper grounding.

Leveling pin for washer feet. Installs at the base to adjust appliance height and stability. Replace if broken, missing, or stripped threads.

Short hinge pin that secures and aligns your washer door for smooth operation. Replace if original is broken, worn, or missing to restore proper fit.

Replacement spin pin for washer agitator assembly. Secures agitator components during wash cycles. Replace if broken, missing, or worn for proper operation.

Replacement door hinge pin for your washer. This short pin secures the door hinge assembly. Order a new one if yours is broken, missing, or worn.

Replacement wheel shaft for washer. Installs on wheel assembly to support rotation. Order if original shaft is bent, broken, or worn causing instability.

This top panel pin secures the range's upper/top panel to the appliance frame so the panel stays aligned and stable for safe, reliable use. It's a simple replacement part that restores proper panel fit and reduces rattling. What it does:

• Locks the top/upper panel into position to keep it from shifting or sagging
• Helps eliminate panel movement, noise, and misalignment during use
• Restores a secure fit if the original pin is broken, bent, or missing
• Works as a direct-fit replacement where this OEM pin is specified

• One top panel pin

• Disconnect power to the appliance before any service to avoid shock or injury
• Access may require removing the cooktop or backguard
• Inspect surrounding clips, hinges, and mounting points and replace if damaged

This front panel pin secures a range or appliance control/front panel to the cabinet, keeping the panel aligned and stable for safe operation. It's a small but important fastener that prevents panel sag and rattles. What it does:

• Secures the front/control panel to the appliance cabinet so the panel stays in place
• Keeps panel edges aligned for a clean fit and proper button/knob operation
• Prevents vibration noise or rattling caused by a loose or broken pin
• A worn or broken pin can allow the panel to move, feel loose, or misalign

• One front panel pin

• Disconnect power to the appliance before beginning any repair
• Typically accessed by removing the console or front panel screws; retain screws and small parts
• Replace the pin carefully to avoid damaging the panel or surrounding trim

Replacement suspension rod for washer tub support system. Connects tub to frame to stabilize during spin cycles. Order new rod if bent, broken, or missing.