General Electric Washer Touch Pad

This backsplash assembly is the rear console housing for a washer's controls. It supports and protects the user interface components and finishes the top, restoring a secure, aligned control area when the original panel is cracked or loose.

• Houses and supports the washer's control components and mounting hardware
• Shields wiring and controls from splashes at the rear of the top panel
• Restores proper fit and alignment for knobs, buttons, and overlays
• Common symptoms: cracked or broken console, loose or rattling controls, broken mounting tabs, cosmetic damage

• Disconnect power and, turn off water supply before servicing
• Remove control knobs and screws/clips securing the console; carefully lift the assembly
• Label or photograph wiring and transfer controls/mounting hardware to the new panel
• Reinstall, ensuring all tabs and screws are fully seated; watch for sharp edges

This backsplash assembly replaces the rear panel on a freestanding range to restore wall protection and the appliance's finished rear appearance. It covers openings at the back and helps keep wiring and components protected and tidy. What it does:

• Covers the rear opening of the range to protect the wall from heat, grease and spills.
• Conceals wiring and access holes to help keep connections protected and out of view.
• Restores damaged, dented, rusted or missing rear trim caused by impacts, corrosion or wear.
• Provides the correct mounting surface for rear-mounted trim and components.

• Disconnect power to the appliance at the breaker before beginning any service.
• Remove the range from the wall if needed to access mounting screws; have a helper if the range is heavy.
• Hold the new backsplash in place and confirm alignment before tightening fasteners; retain original screws if replacement hardware is not supplied.

This replacement backsplash assembly restores the finished rear panel on compatible ranges, protecting the wall behind the cooktop and returning the appliance's original appearance. Use it when the original panel is bent, rusted or cosmetically damaged. What it does

• Covers and protects the rear area of the cooktop from heat, grease and splatter
• Restores the appliance's finished look after dents, scratches or corrosion
• Provides the mounting surface for rear-mounted controls and components
• Prevents drafts and gaps behind the range that can collect debris

• Disconnect power to the range before beginning any service to avoid shock
• Typical installation requires removing a few screws and lifting the old panel out; basic hand tools are usually sufficient
• Take care with sharp edges and painted surfaces to avoid cuts or damage

This backsplash assembly replaces a damaged or worn rear backguard on ranges and cooktops, restoring a clean appearance and covering the appliance's rear controls and wiring for safe, reliable operation. What it does:

• Covers and protects the range's rear control area and internal wiring from spills, heat, and debris
• Restores a finished look when the original backguard is dented, scratched, bent, or missing
• Provides mounting surface for controls and trim components when applicable
• Helps maintain proper airflow and safety clearances around rear components

• Disconnect power to the appliance before starting any repair
• Removal of control panel or trim may be required; follow OEM instructions
• Handle carefully to avoid scratching finished surfaces; two people may be helpful for alignment