Gibson Support Parts

Right side backguard support bracket for ranges. Replaces cracked, broken, or missing white backguard support. Structural component for secure installation.

Reinforces and supports oven door glass panels. Replace if original stiffener is bent, cracked, or missing to properly secure glass in the door frame.

Mounting plate that secures the oven to the cabinet or wall. Replace this metal support plate if it's bent, rusted, or missing to ensure proper installation.

This left-side tapping plate/gusset is a metal mounting bracket that reinforces appliance panels and hinge areas, restoring secure attachment and alignment for doors or panels. It helps reduce wobble and maintains proper fit where the original bracket is damaged or worn. What it does:

• Reinforces and secures hinge or panel attachment points to restore alignment
• Provides a threaded or tapped surface for fasteners where sheet metal cannot accept screws
• Stops movement or sagging that can cause gaps, noise, or poor door sealing
• Helps prevent further damage to the cabinet or door mounting area

• Always disconnect power (and water, if applicable) before beginning repairs
• Inspect mounting holes and surrounding metal; remove any damaged fasteners or debris before installing
• Use the correct replacement screws and hand-tighten, then torque to manufacturer specs if available; do not over-tighten
• If the cabinet or hinge area is severely corroded or stripped, additional repair or reinforcement may be required

Mounting base that secures the compressor to your refrigerator frame. Replace if cracked, broken, or damaged to properly support the compressor unit.

Support plate that secures the burner tube assembly in your range. Replace if cracked, warped, or corroded to properly mount and stabilize burner components.

Mounting plate for electric and gas ranges. Secures components in place. Replace if cracked, bent, or broken to restore proper structural support.

This channel burner support is a stamped support bracket designed to hold and align the range burner channel and related components so burners sit correctly. It helps restore proper fit and stable burner operation. What it does:

• Secures the burner channel and keeps burners aligned for consistent heating
• Prevents wobbling or misalignment of the burner assembly during use
• Helps maintain correct spacing between burner components and gas valve/manifold
• Commonly replaced when the original support is bent, cracked, or damaged

• One channel burner support bracket

• Designed to mount with existing fasteners; inspect screws or clips and replace if worn
• Turn off power and gas supply (for gas ranges) before servicing; follow appliance safety procedures
• Handle sharp edges carefully; wear gloves to avoid cuts