Jenn-Air Dishwasher Pump

The Check Valve is an OEM part for Whirlpool dishwashers. This valve is a component that allows water to flow in one direction only, from the water inlet into the dishwasher. 

Causes of a bad check valve can include mineral or debris buildup interfering with the valve operation over several years of use. Damage is also possible if the water connection is faulty.

Symptoms of a bad check valve include:

• Water flowing backward out of the dishwasher or inlet hose
• Inability to properly fill or circulate water during cycles  
• Potential leaks or standing water below the appliance

This essential Whirlpool replacement is compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper and Kenmore models as well. 

The Pump Housing is an OEM part for Whirlpool dishwashers. As a central component, it contains the circulating pump that drives wash water through spray arms for thorough cleaning.

Symptoms of a bad pump housing include:

• Puddles or leaks from under the dishwasher main unit
• Limited or no water pressure to upper and lower spray arms  
• Water that does not properly drain at the end of a cycle
• Drying issues caused by residual water collection 

Causes can be cracks that develop from regular pump cycling stresses over time, or impact damage compromising seals and gaskets.

This OEM Whirlpool part is also compatible with some KitchenAid, Jenn-Air, and GE dishwashers.

This chopper assembly replaces the food-chopping component in compatible countertop food processors, restoring even chopping and diced results. It helps get blades turning and keeps food processing performing as intended. What it does:

• Spins and chops food inside the processor bowl for consistent results
• Restores proper cutting when chopping is uneven or not happening
• Helps eliminate food buildup that causes noisy or inefficient operation
• Works with the existing drive coupling to transfer motor power to the blades

• Disconnect power and remove the processor bowl and lid before servicing
• Handle blades carefully — they are sharp; wear cut-resistant gloves
• Ensure the part seats fully on the drive coupling and locks into place before use
• Test operation with small amounts of food after reassembly; stop immediately if unusual noise or resistance occurs

This drain impeller assembly circulates and ejects wash water through the washer's drain pump, restoring proper drainage and helping prevent standing water after a cycle. Durable design fits into the pump housing for reliable performance. What it does:

• Presses water through the pump housing to enable normal draining during drain/spin cycles
• Replaces worn or damaged impeller vanes that can cause slow or no draining
• Helps reduce noise and vibration from an imbalanced or broken impeller
• Restores proper water flow when the pump motor runs but little or no water is expelled

• Disconnect power and water supply before starting any repair
• Access requires removing the washer cabinet or pump housing depending on model
• Inspect pump housing and sealing surfaces for damage or debris before installing the new impeller
• Use common hand tools; tighten fasteners to OEM torque specs where provided

Seal not included